W415-0788 / F / 10.21.1325EN5.0 INSTALLATION! WARNINGENSURE TO UNPACK ALL LOOSE MATERIALS FROM INSIDE THE FIREBOX PRIOR TO HOOKING UPTHE GAS AND ELECTRICAL SUPPLY.IF YOUR APPLIANCE IS SUPPLIED WITH A REMOTE ENSURE THE REMOTE RECEIVER IS IN THE“OFF” POSITION PRIOR TO HOOKING UP THE GAS AND ELECTRICAL SUPPLY TO THE APPLIANCE.FOR SAFE AND PROPER OPERATION OF THE APPLIANCE, FOLLOW THE VENTING INSTRUCTIONSEXACTLY.ALL INNER EXHAUST AND OUTER INTAKE VENT PIPE JOINTS MAY BE SEALED USING EITHER REDRTV HIGH TEMP SILICONE SEALANT W573-0002 (NOT SUPPLIED) OR BLACK HIGH TEMP MILL PACW573-0007 (NOT SUPPLIED) WITH THE EXCEPTION OF THE APPLIANCE EXHAUST FLUE COLLARWHICH MUST BE SEALED USING MILL PAC.IF USING PIPE CLAMPS TO CONNECT VENT COMPONENTS, 3 SCREWS MUST ALSO BE USED TOENSURE THE CONNECTION CANNOT SLIP OFF.DO NOT CLAMP THE FLEXIBLE VENT PIPE.RISK OF FIRE, EXPLOSION OR ASPHYXIATION. IMPROPER SUPPORT OF THE ENTIRE VENTINGSYSTEM MAY ALLOW VENT TO SAG AND SEPARATE. USE VENT RUN SUPPORTS AND CONNECTVENT SECTIONS PER INSTALLATION INSTRUCTIONS.RISK OF FIRE, DO NOT ALLOW LOOSE MATERIALS OR INSULATION TO TOUCH THE VENT PIPE.REMOVE INSULATION TO ALLOW FOR THE INSTALLATION OF THE ATTIC SHIELD AND TOMAINTAIN CLEARANCES TO COMBUSTIBLES.68.2B5.1 MINIMUM CLEARANCE TO COMBUSTIBLESGDS60:HORIZONTAL VENT SECTIONS: A minimum clearance of 2" (50.8mm) at the top and 1" (25.4mm) at the bottom andsides of the vent pipe on all horizontal runs is required.VERTICAL VENT SECTIONS: A minimum of 1" (25.4mm) all around the vent pipe on all vertical runs to combustibles isrequired.GS60:A minimum of 1" (25.4mm) all around the B vent pipe on both horizontal and vertical runs to combustibles is required.MAINTAIN THESE MINIMUM CLEARANCES TO COMBUSTIBLES:A. 6" (152.4mm) B. 6" (152.4mm) C. 2" (50.8mm)*Minimum 20" (508mm) from appliance top to ceiling.6" (152.4mm) to single wall connector.*At a distance of 2" (50.8mm) from the wall, access to the blower switch, on-off switch or the blower power cord may not bepractical.
