Napoleon GL18NE Installation And Operating Instructions Manual

Also see for GL18PE: Installation and operation manual Installation and operating instructions Installation and operating instructions

Contents

Napoleon GL18NE Installation And Operating Instructions Manual Manual pdf 15 page image

15W415-1071 / C / 01.11.127.3 FLAME CHARACTERISTICSIt’s important to periodically perform a visual check of the pilot and burner flames. Compare them to theillustrations provided. If any flames appear abnormal call a service person.FLAME MUST ENVELOPUPPER 3/8” TO 1/2” OFFLAME SENSORPILOTBURNERELECTRODEFLAMESENSOR54.1ACAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improperand dangerous operation. Verify proper operation after servicing. This appliance and its venting system shouldbe inspected before use and at least annually by a qualified service person. The appliance area must bekept clear and free of combustible materials, gasoline or other flammable vapours and liquids. The flow ofcombustion and ventilation air must not be obstructed.1. In order to properly clean the burner and pilot assembly, remove the logs, rocks and/or glass toexpose both assemblies.2. Keep the control compartment, media, burner, air shutter opening and the area surrounding theappliance clean by vacuuming or brushing, at least once a year.3. Check to see that all burner ports are burning. Clean out any of the ports which may not be burning orare not burning properly.4. Check to see that the pilot flame is large enough to engulf the flame sensor and/or thermocouple /thermopile as well as reaches the burner.5. Replace the cleaned logs, rocks or glass. Failure to properly position the media may cause carboningwhich can be distributed in the surrounding living area.6. Check to see that the main burner ignites completely on all openings when turned on. A 5 to 10second total light-up period is satisfactory. If ignition takes longer, consult your local authorized dealer /distributor.7. Visually inspect the appliance for carbon build up. Using a small whisk or brush, brush off the carbonand vacuum up or sweep into garbage.8. Check to see that the appliance is venting correctly. Ensure chimney system is safe and unobstructed.40.19MAINTENANCEMAINTENANCEMAINTENANCETURN OFF THE GAS AND REMOVE BATTERIES BEFORE SERVICING THE APPLIANCE.APPLIANCE MAY BE HOT, DO NOT SERVICE UNTIL APPLIANCE HAS COOLED.DO NOT USE ABRASIVE CLEANERS.! WARNING8.0 MAINTENANCE