Napoleon GSS36CFN Installation And Operation Manual

Napoleon GSS36CFN Installation And Operation Manual Manual pdf 17 page image

6.0 gas installation! WARNING• Risk of fire, explosion, or asphyxiation. Ensure there are no ignition sources such as sparks or open flames.• Support gas control when attaching gas supply pipe to prevent damaging gas line.• Purging of the gas supply line should be performed by a qualified service technician. Ensure that a continuousgas flow is at the burner before closing the door. Ensure adequate ventilation. For gas and electrical locations,see “appliance dimensions” section.• All gas connections must be contained within the appliance when complete.• High pressure will damage valve. Disconnect gas supply piping before testing gas line at test pressures above1/2 PSIG.• Valve settings have been factory set, do not change.Installation and servicing to be done by a qualified installer.• Move the appliance into position and secure.• If equipped with a flex connector, the appliance is designed to accept a 1/2” (13mm) gas supply. Without theconnector, it is designed to accept a 3/8” (9.5mm) gas supply. The appliance is equipped with a manual shutoff valve to turn off the gas supply to the appliance.• Connect the gas supply in accordance to local codes. In the absence of local codes, install to the currentCAN/CSA-B149.1 Installation Code in Canada or to the current National Fuel Gas Code, ANSI Z223.1 / NFPA54 in the United States.• When flexing any gas line, support the gas valve so that the lines are not bent or kinked.• The gas line flex-connector should be installed to provide sufficient movement for shifting the burner assemblyon its side to aid with servicing components.• Check for gas leaks by brushing on a soap and water solution. Do not use open flame.ENW415-1796 / A / 05.17.1817