Napoleon GVF36P Installation And Operation Instructions Manual

Also see for GVF36N: Installation and operating instructions Installation and operating instructions Installation and operation instructions Installation and operating instructions Installation and operation instructions

Napoleon GVF36P Installation And Operation Instructions Manual Manual pdf 17 page image

17W415-0297 / L / 10.23.08This procedure must be performed by a qualified service person!Inspect the pilot for any visible contamination or debris(usually lint, pet hair, spider webs, carpet fibre, etc.)and remove.Disconnect the pilot from the pilot tubing line,using a 7/16” wrench. Blow out the housing inthe same direction as the gas flow. Re-installthe pilot tube, turn on the gas and check forleaks.If this does not improve the performance, replacethe pilot with an exact replacement. The device is tamper resistant with no field serviceable parts.CORRECT PILOTFLAMEINCORRECTPILOT FLAMEFIGurE 7.1a FIGurE 7.1b7.1 OxyGEN dEpLETION SENSOr pILOT CLEANINGAir shutter adjustment must only be done by a qualified gas installer!Closing the air shutter will cause a more yellow flame, but can lead to carboning.Opening the air shutter will cause a more blue flame, but can cause flame liftingfrom the burner ports. The flame may not appear yellow immediately; allow 15 to30 minutes for the final flame colour to be established.Opening the air shutter will also reduce exhaust odours smelled within the room. See Trouble Shooting Guide.Carbon can be distributed in surrounding living area if the air shutter is improperly adjusted.! WARNINGaIr shuTTEr OPENINGsNG 3/16”LP 1/2”FIGurE 8.18.1 vENTurI AdjuSTmENT8.0 AdjuSTmENT