Napoleon GVF36P Installation And Operation Instructions Manual

Also see for GVF36N: Installation and operating instructions Installation and operating instructions Installation and operation instructions Installation and operating instructions Installation and operation instructions

Napoleon GVF36P Installation And Operation Instructions Manual Manual pdf 6 page image

6W415-0297 / L / 10.23.081.5 CArE OF pLATEd pArTS1.4 GENErAL INFOrmATIONFOR YOUR SATISFACTION, THIS HEATER HAS BEEN TEST-FIRED TO ASSURE ITS OPERATION AND QUALITY!Minimum inlet gas supply pressure is 4.5 inches water column for natural gas and 11 inches water column for propane. Maximum inletgas pressure is 7 inches water column for natural gas and 13 inches water column for propane. Manifold pressure under flow conditionsis 3.5 inches water column for natural gas and 10 inches water column for propane.No external electricity (110 volts or 24 volts) is required for the gas system operation. Expansion / contraction noises during heating upand cooling down cycles are normal and are to be expected.This heater is equipped with a pilot light safety system referred to as an oxygen depletion sensor and is designed to turn off the heater ifnot enough fresh air is available.Use only accessories designed for and listed with your specific heater.! WARNINGCARBON MONOXIDE POISONING MAY LEAD TO DEATHEarly signs of carbon monoxide poisoning resemble the flu, with headache, dizziness and/or nausea. If you have these signs, theheater may not be working properly. Get fresh air at once! Have heater serviced.Some people---pregnant women, persons with heart or lung disease, anemia, those under the influence of alcohol, those at highaltitudes--- are more affected by carbon monoxide than others.This heater must not be installed in a bedroom or bathroom.The heater is only for use with the type of gas indicated on the rating plate. This heater is not convertible for use with other gases.Objects placed in front of the heater should be kept a minimum of 48” away from the glass front faces of the heater.Maximum input is 30,000 BTU/hr for natural gas and propane. When the fireplace is installed at elevationsabove 2,000ft, and in the absence of specific recommendations from the local authority having jurisdiction, thecertified high altitude input rating shall be reduced at the rate of 4% for each additional 1,000ft.TP - GENERAL iNFORmATiON_vFTP - CARE OF PLATEd PARTSSuitable for mobile home installation where the mobile home has been permanently placed on its side. This heatermust not be installed in a bedroom or bathroom.This fireplace may be installed in an aftermarket permanently located, manufactured (mobile) home, where notprohibited by local codes.If the appliance is equipped with plated parts, you must clean fingerprints or other marks from the plated surfaces beforeoperating the appliance for the first time. Use a glass cleaner or vinegar and towel to clean. If not cleaned properly beforeoperating for the first time, the marks can cause permanent blemishes on the plating. After the plating is cured, thefingerprints and oils will not affect the finish and little maintenance is required, just wipe clean as needed.NOTE: The protective wrap on plated parts is best removed when the assembly is at room temperature but thiscan be improved if the assembly is warmed, using a hair dryer or similar heat source.1.6 mOBILE hOmE