Napoleon GVFL18 Installation And Operating Instructions Manual

Also see for GVFL18: Installation and operating instructions

Contents

Napoleon GVFL18 Installation And Operating Instructions Manual Manual pdf 11 page image

11W415-0809 / B / 01.07.113.3 GAS PIPING! WARNINGDO NOT CONNECT EITHER THE WALL SWITCH, THERMOSTAT OR GAS VALVE TO ELECTRICITY(110 VOLTS).This appliance and it’s appliance main valve must be disconnected from the gas supply piping system duringany pressure testing of that system at test pressures in excess of ½ PSI (3.5kPa)This appliance must be isolated from the gas supply pipingsystem by closing the individual manual shut off valve during anypressure testing of the gas supply piping system at test pressureequal to or less than ½ psi (3.5 kPa)A. Centre the appliance in the appliance opening, makingsure the appliance has enough room behind it for the gasline to run behind the log set under the log support.B. Route the gas line and sizing using piping ½” diameter orgreater to allow the full volume of gas to the appliance.The routing of the gas line has to be done to local and /or national codes.C. When rigid pipe is used an ANSI approved manual shutoff and a union must be installed upstream within theappliance cavity.D. To ensure the appliance operates reliably install asediment trap upstream of the appliance within the structures of the piping system.E. When using propane, a regulator must be used between the tank and the outside wall of the house toensure the line pressure does not exceed 14” w.c.F. Check gas connections with a gas detection device to test for leaks in the system. Soapy watermixture can also be used to check for leaks.G. Once all the gas connections are tested for leaks, start the appliance. Follow the lighting instructionsto ensure the appliance is working properly before finishing.Regulator UnionManualShut-OffValveWallShut-OffKeySedimentTrapApplianceAppliance3"4.0 FINISHING4.1 ANDIRON AND GRATE ASSEMBLYA. With the 2 andirons laying facedown, secure the grate overtopusing 2x ¼-20 bolts (supplied in themanual baggie).B. Install the grate/andiron assemblyto the burner base using 4x ¾” selftapping screws (supplied in themanual baggie).12USE ONLY ACCESSORIESDESIGNED FOR ANDLISTED WITH YOURSPECIFIC LOG SET.