Napoleon GX70NT Installation And Operating Instructions Manual

Contents

Napoleon GX70NT Installation And Operating Instructions Manual Manual pdf 6 page image

6W415-1519 / C / 11.06.15EN2.2 GENERAL INSTRUCTIONS4.1BTHIS GAS APPLIANCE SHOULD BE INSTALLED AND SERVICED BY A QUALIFIED INSTALLER toconform with local codes. Installation practices vary from region to region and it is important to know thespecifics that apply to your area, for example in Massachusetts State:• This product must be installed by a licensed plumber or gas fitter when installed within the commonwealthof Massachusetts.• The appliance damper must be removed or welded in the open position prior to installation of an applianceinsert or gas log.• The appliance off valve must be a “T” handle gas cock.• The flexible connector must not be longer than 36 inches (914mm).• A Carbon Monoxide detector is required in all rooms containing gas fired appliances.• The appliance is not approved for installation in a bedroom or bathroom unless the unit is a direct ventsealed combustion product.The installation must conform with local codes or, inabsence of local codes, the National Gas and PropaneInstallation Code CSA B149.1 in Canada, or the NationalFuel Gas Code, ANSI Z223.1 / NFPA 54 in the UnitedStates. Suitable for mobile home installation if installed inaccordance with the current standard CAN/CSA Z240MHSeries, for gas equipped mobile homes, in Canada orANSI Z223.1 and NFPA 54 in the United States.As long as the required clearance to combustibles ismaintained, the most desirable and beneficial locationfor an appliance is in the center of a building, therebyallowing the most efficient use of the heat created. The location of windows, doors and the traffic flow in theroom where the appliance is to be located should be considered. If possible, you should choose a locationwhere the vent will pass through the house without cutting a floor or roof joist.If the appliance is installed directly on carpeting, vinyl tile or other combustible material other than woodflooring, the appliance shall be installed on a metal or wood panel extending the full width and depth.Some appliances have optional fans or blowers. If an optional fan or blower is installed, the junction box mustbe electrically connected and grounded in accordance with local codes, use the current CSA C22.1 CanadianElectrical Code in Canada or the ANSI/NFPA 70 National Electrical code in the United States.We suggest that our gashearth products be installedand serviced by professionalswho are certified in the U.S.by the National FireplaceInstitute® (NFI) as NFI GasSpecialistswww.nficertified.orgALWAYS LIGHT THE PILOT WHETHER FOR THE FIRST TIME OR IF THE GAS SUPPLY HAS RUN OUT,WITH THE GLASS DOOR OPENED OR REMOVED.PROVIDE ADEQUATE CLEARANCE FOR SERVICING AND OPERATING THE APPLIANCE.PROVIDE ADEQUATE VENTILATION.NEVER OBSTRUCT THE FRONT OPENING OF THE APPLIANCE.OBJECTS PLACED IN FRONT OF THE APPLIANCE MUST BE KEPT A MINIMUM OF 48” (1219mm) FROMTHE FRONT FACE OF THE APPLIANCE.SURFACES AROUND AND ESPECIALLY ABOVE THE APPLIANCE CAN BECOME HOT. AVOID CONTACTWHEN THE APPLIANCE IS OPERATING.FIRE RISK. EXPLOSION HAZARD.HIGH PRESSURE WILL DAMAGE VALVE. DISCONNECT GAS SUPPLY PIPING BEFORE PRESSURE TESTING GASLINE AT TEST PRESSURES ABOVE 1/2 PSIG. CLOSE THE MANUAL SHUT-OFF VALVE BEFORE PRESSURETESTING GAS LINE AT TEST PRESSURES EQUAL TO OR LESS THAN 1/2 PSIG (35 mb).USE ONLY WOLF STEEL APPROVED OPTIONAL ACCESSORIES AND REPLACEMENT PARTS WITH THIS APPLIANCE.USING NON-LISTED ACCESSORIES (BLOWERS, DOORS, LOUVRES, TRIMS, GAS COMPONENTS, VENTINGCOMPONENTS, ETC.) COULD RESULT IN A SAFETY HAZARD AND WILL VOID THE WARRANTY AND CERTIFICATION.! WARNING