Napoleon HD35NT Installation And Operating Instructions Manual

Also see for HD35NT: Installation and operating instructions Installation and operating instructions Installation and operating instructions

Contents

Napoleon HD35NT Installation And Operating Instructions Manual Manual pdf 24 page image

24W415-0750 / 12.17.08Proceed once the vent installation is complete.● Move the fireplace into position and secure to the floor.● The fireplace is designed to accept 1/2" gas supply line. The fireplace is equipped with a 1/2" manualshut-off valve.● Connect the gas supply in accordance to local codes. In absense of local codes, install to the currentCAN1-B149 installation Code in Canada or to the current National Fuel Gas Code, ANSI Z223.1 /NFPA 54 in the Unitied States.● Connect the supply gas pipe so that there issufficient play in the flex connector to enablethe entire burner base to be shifted or partiallyremoved (to aid with servicing components).● When flexing any gas line, support the gas valve so that the lines are not bent or kinked.● Check for gas leaks by brushing on a soap and water solution.NOTE: For high altitude installation see “GENERAL INFORMATION” section.Shown in“OFF”position.ManualShut-off Valve3.6 gAS INSTALLATIONtp - gas installation_353.5.1 Unscrew the 4 screws that hold the Access Panelto the firebox.3.5.2 Remove the Gasket (careful not to tear).AccessPanelGasket3.5 ACCESS pANEL FOr gAS LINE CONNECTIONfIgure 3.5fIgure 3.6.23.6.1.3.6.2.3.6.3.3.6.43.6.53.6.6! WARNINGRisk of fire, explosion or asphyxiation. Ensure there are no ignition sources such as sparks or openflames.Support gas control when attaching gas supply pipe to prevent damaging gas line.Always light the pilot whether for the first time or if the gas supply has run out with the glass dooropened or removed. Purge should be performed by a qualified service technician. Assure that acontinuous gas flow is at the burner before closing the door. Ensure adequate ventilation. For gasand electrical locations, see “DIMENSION” section.All gas connections must be contained within the fireplace when complete.High pressure will damage valve. Low pressure may cause a leak and explosion.Valve settings have been factory set, do not change.