Napoleon HD35NT Installation And Operating Instructions Manual

Also see for HD35NT: Installation and operating instructions Installation and operating instructions Installation and operating instructions

Contents

Napoleon HD35NT Installation And Operating Instructions Manual Manual pdf 8 page image

8W415-0750 / 12.17.081.8 gENErAL INFOrmATIONFOR YOUR SATISFACTION, THIS FIREPLACE HAS BEEN TEST-FIRED TO ASSURE ITS OPERATION ANDQUALITY!This fireplace is approved for bathroom, bedroom and bed-sitting room installations and is suitable for mobile homeinstallations.This fireplace is only for use with the type of gas indicated on the rating plate. This fireplace is not convertible for use withother gases, unless a certified kit is used.Expansion / contraction noises during heating up and cooling down cycles are normal and are to be expected. Changes inflame appearance from “HI” to “LO” is more evident in natural gas than in propane.Use only accessories designed for and listed with your specific fireplace.High ElevationsInput ratings are shown in Btu per hour and are certified without de-rating up to 4,500 feet above sea level. For Installa-tions at the elevations above 4,500 feet and in the absence of specific recommendations from the local authority havingjurisdiction, the high altitude input rating shall be reduced at the rate of 4% for each additional 1,000 feet.gas specIfIcatIonsmodel fuel gascontrolmax.Inputbtu/hmin.Inputbtu/hair shuttersettinghD35nt Nat IPI Hi/Lo 25,000 17,500 1/8” OpenhD35pt Prop* IPI Hi/Lo 25,000 17,500 5/16” OpenhD40nt Nat IPI Hi/Lo 27,000 18,900 1/8” OpenhD40pt Prop* IPI Hi/Lo 27,000 18,900 3/8” Opengas Inlet and manIfold pressuresnatural propaneminimum Inlet 4.5” w.c. 11.0” w.c.maximum Inlet 7.0” w.c. 13.0” w.c.manifold pressure 3.5” w.c. 10.0” w.c.effIcIency ratIngsmodel steady state(%) afue%**hD35nt 82.1% 77.2%hD35pt 82.1% 77.2%hD40nt 80.5% 76.3%hD40pt 80.5% 76.3%IPI - Intermittent Pilot Ignition System* Using conversion kit** Maximum ValuesConversions must be made by a qualified servicetechnician using Wolf Steel specified and approvedparts.1.6 CArE OF gLASSDO NOT CLEAN GLASS WHEN HOT! DO NOT USE ABRASIVECLEANERS TO CLEAN GLASS.Buff lightly with a clean dry soft cloth. Clean the glass after the first 10hours of operation with a recommended fireplace glass cleaner.Thereafter clean as required. If the glass is not kept clean permanentdiscoloration and / or blemishes may result.HOT GLASS WILLCAUSE BURNS.DO NOT TOUCH GLASSUNTIL COOLED.NEVER ALLOW CHILDRENTO TOUCH GLASS.! WARNINGtp - care of glass atp - care of plateD parts63.3%HD3563.3%HD3564.3%HD401.7 CArE OF pLATEd pArTSIf the appliance is equipped with plated parts, you must clean fingerprints or other marks from the plated surfaces beforeoperating the appliance for the first time. Use a glass cleaner or vinegar and towel to clean. If not cleaned properly beforeoperating for the first time, the marks can cause permanent blemishes on the plating. After the plating is cured, thefingerprints and oils will not affect the finish and little maintenance is required, just wipe clean as needed.Prolonged high temperature burning with the door ajar may cause a permanent rain bowing effect on the lower edge of agold plated door (applies to wood product only).NOTE: The protective wrap on plated parts is best removed when the assembly is at room temperature but thiscan be improved if the assembly is warmed, using a hair dryer or similar heat source.These fireplaces are equipped with tempered glass. Replacement glass must be obtained from your autho-rized dealer / distributor and is identified in the replacement parts list. Do not substitute materials.