Napoleon HD35PT-2 Installation And Operation Manual

Also see for HD35NT-2: Installation and operating instructions

Napoleon HD35PT-2 Installation And Operation Manual Manual pdf 52 page image

W415-2197 / B / 08.28.18EN52maintenance12.3 care of glass12.4 care of plated parts12.2 door glass replacement38.1! WARNING• Do not use substitute materials.• Glass may be hot. Do not touch glass until cooled.• Care must be taken when removing and disposing of any broken door glass or damaged components. Besure to vacuum up any broken glass from inside appliance before operation.• Do not strike, slam, or scratch. Do not operate appliance with glass removed, cracked, broken, or scratched.38.1.1Replacement glass/frame assembly shall be replaced as a complete unit as supplied by the appliancemanufacturer.THIS TEMPLATE MUST BE USED WITH 38.1! WARNINGBuff lightly with a clean dry soft cloth to remove accumulated dust or fingerprints. Clean both sides of the glassafter the first 10 hours of operation with an ammonia-free glass cleaner.Thereafter, clean as required. If the glass is not kept clean permanent discoloration and / or blemishes mayresult. Contact you local authorized dealer / distributor for complete cleaning instructions.Razor blades, steel wool, or other metallic objects must not be used on both surfaces of the glass. Doing socan remove a thin layer of metal from the razor blades, steel wool, or other metallic objects that may then bedeposited onto the coating. This can result in a discoloured stain or scratch-like mark. More importantly, this canscratch the glass surface, thereby reducing its strength.Do not operate the appliance with broken glass, as leakage of flue gases may result.Contact your local authorized dealer / distributor for complete cleaning instructions.If the glass should ever crack or break while the fire is burning, do not open the door until the fire is out. Do notoperate the appliance until the glass has been replaced. Contact you local authorized dealer / distributor forreplacement parts. DO NOT SUBSTITUTE MATERIALS.5.1AVinegar-based glass cleaners have demonstrated an ability to provide a clean, streak free glass surface.note:• Do not clean glass when hot! Do not use abrasive cleaners to clean glass.5.1.2This appliance is factory equipped with 5mm tempered glass. Use only replacement parts as supplied by theappliance manufacturer. DO NOT SUBSTITUTE MATERIALS.6.1If the appliance is equipped with plated parts, you must clean fingerprints or other marks from the plated surfacesbefore operating the appliance for the first time. Use an ammonia-free or vinegar-based cleaner and a towelto clean. If not cleaned properly before operating for the first time, the marks can cause permanent blemisheson the plating. After the plating is cured, the fingerprints and oils will not affect the finish and little maintenanceis required, just wipe clean as needed. Prolonged high temperature burning with the door ajar may causediscolouration on plated parts.The protective wrap on plated parts is best removed when the assembly is at room temperature but this canbe improved if the assembly is warmed (i.e. using a hair dryer or similar heat source).note: