Napoleon HD81NT Installation And Operating Instructions Manual

Also see for HD81NT: Installation and operating instructions Installation and operating instructions Installation and operating instructions Installation and operating instructions

Contents

Napoleon HD81NT Installation And Operating Instructions Manual Manual pdf 47 page image

W415-1406 / 11.19.1447ENA. Place the door frame face down careful not toscratch the paint.B. Center the gasketed glass inside the door framewith the thick side of the gasket facing up.C. Bend the glass retainers located along the edgeof the door frame over the gasket holding theglass in place. Careful not to break the glass.! WARNINGDO NOT USE SUBSTITUTE MATERIALS.GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.CARE MUST BE TAKEN WHEN REMOVING AND DISPOSING OF ANY BROKEN DOOR GLASS ORDAMAGED COMPONENTS. BE SURE TO VACUUM UP ANY BROKEN GLASS FROM INSIDE THEAPPLIANCE BEFORE OPERATION.DO NOT STRIKE, SLAM OR SCRATCH GLASS. DO NOT OPERATE APPLIANCE WITH GLASSREMOVED, CRACKED, BROKEN OR SCRATCHED.56.1A5.1DO NOT CLEAN GLASS WHEN HOT! DO NOT USEABRASIVE CLEANERS TO CLEAN GLASS.Buff lightly with a clean dry soft cloth. Clean both sidesof the glass after the first 10 hours of operation with arecommended fireplace glass cleaner. Thereafter cleanas required. If the glass is not kept clean permanentdiscoloration and / or blemishes may result.HOT GLASS WILLCAUSE BURNS.DO NOT TOUCH GLASSUNTIL COOLED.NEVER ALLOW CHILDRENTO TOUCH GLASS.! WARNING6.1If the appliance is equipped with plated parts, you must clean fingerprints or other marks from the platedsurfaces before operating the appliance for the first time. Use a glass cleaner or vinegar and towel to clean.If not cleaned properly before operating for the first time, the marks can cause permanent blemishes onthe plating. After the plating is cured, the fingerprints and oils will not affect the finish and little maintenanceis required, just wipe clean as needed. Prolonged high temperature burning with the door ajar may causediscolouration on plated parts.NOTE: The protective wrap on plated parts is best removed when the assembly is at roomtemperature but this can be improved if the assembly is warmed, using a hair dryer or similar heatsource.11.6 GLASS / DOOR REPLACEMENT11.7 CARE OF GLASS11.8 CARE OF PLATED PARTSGLASSGASKETDOORFRAMEGLASSRETAINER5.5.1This appliance is factory equipped with 5mm ceramic glass. Use only replacement glass available from yourNapoleon® dealer. DO NOT SUBSTITUTE MATERIALS.