Napoleon Hybrid HMF200 Installation And Operating Instruction

Also see for HMF150: Operating instructions Installation and operating instructions

Contents

Napoleon Hybrid HMF200 Installation And Operating Instruction Manual pdf 13 page image

W415-1013 / B / 07.24.1313enriGHT Hand ra4.6 mOuNTING PrImAry AIr CONTrOLlefT Hand ralocation of the Primary air Control in left and right ra.IMpoRTANT:This step must follow the plenum installation in Section 6.0. The plenum is not shown in diagrams below, forclarity purposes.1. attach vertical Guide bracket (vGb) to the Top of the rear air supply chamber.a. Centre the VGB around the control rod opening as per diagram and position the two vertical fingers ofthe VGB so the bend in these fingers are flush with the back side of the shutter plate.b. locate vGb on screws inserted in the predrilled holes of the rear air supply chamber, as per diagrams.do noT TiGHTen SCrewS So braCkeT Can be adJuSTed.c. with shutter plate pushed towards the front of the furnace in the air damper assembly slot, and the baseof the VGB held firmly down on the top of the air supply chamber, position the bend in the vertical fingersso there is a 0” to 1/32” gap between the back of the shutter plate and the bend in the vertical fingers.FLUSH TOSHUTTER PLATEHOLD SHUTTERPLATE FORWARDTOWARDS FRONTOF FURNACESHUTTERPLATE CONTROLRODOPENINGREAR AIRSUPPLYCHAMBERVGBH3.37ThE FINgERS MUST NoT ExERT ANy FoRWARd FoRCE oN ThE ShUTTER pLATE WITh ThEMoUNTINg SCREWS TIghTENEd. ThE ShUTTER pLATE MUST SLIdE Up ANd doWN FREELy INtHe slOt, anD sHOulD ReaDIlY Fall (gRavItY OnlY) IntO tHe slOt IF RaIseD BY HanD2” (51mm) anD ReleaseD. IF anY tensIOn eXIsts BetWeen vgB anD sHutteR plate, tHeFRICTIoN MAy pREvENT ThE ShUTTER pLATE FRoM FALLINg, CAUSINg ThE FURNACE ToovER FIRE.