W415-1013 / B / 07.24.1369en1. when the appliance is cool, open the door and place the doorframe down careful not to scratch the paint.2. remove the screws , spacers and pins holding the heat shieldon. remove the heat shield.3. remove the screws and brackets holding the insert in place.remove the insert.4. Wrap the edges of the new insert with a “U” shaped strip of fiber-glass gasket, covering 1/4” (6mm) on each side.5. Place the insert with the fiberglass gasket in position and replacethe brackets and screws. when finished you should be able tomove the insert slightly, horizontally and vertically.6. Position the heat shield on the fire box door and replace thespacers, screws and pins.9.6 GLASS rEPLACEmENT1. when the appliance is cool, open the door and place the doorframe down careful not to scratch the paint.2. remove the screws and brackets holding the glass in place.remove all broken glass.3. wrap the edges of the new glass with a u-shaped strip offiberglass gasket, covering 1/4” (6mm) on each side.4. Place the glass with the fiberglass gasket in position and replacethe brackets and screws. When finished, you should be able tomove the glass slightly, horizontally and vertically.NoTEFor replacement glass, size, thickness and specificationssee “rePlaCemenTS” section.9.7 INSuLATION INSErT rEPLACEmENTAt the end of each burning season inspect the fire box door fibre insulation for deterioration or breakage. Re-place if necessary.NoTEfor replacement insulation insert see “rePlaCemenTS” section.! WARNINGDO NOT USE SUBSTITUTE MATERIALS.GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.CARE MUST BE TAKEN WHEN REMOVING AND DISPOSING OF ANY BROKEN DOOR GLASS ORDAMAGED COMPONENTS. BE SURE TO VACUUM UP ANY BROKEN GLASS FROM INSIDE THEAPPLIANCE BEFORE OPERATION.DO NOT STRIKE, SLAM OR SCRATCH GLASS. DO NOT OPERATE APPLIANCE WITH GLASSREMOVED, CRACKED, BROKEN OR SCRATCHED.56.2
