Napoleon Infrared Series Installation Manual

Napoleon Infrared Series Installation Manual Manual pdf 29 page image

ENW415-1802 / A / 11.06.1829maintenance6.1 annual maintenance6.2 care of glass24.1! WARNING• This appliance will require maintenance which should be planned on an annual basis.• Service should include cleaning, battery replacement, venting inspection and inspection of the burner,media, and firebox. Refer to the door removal section and remove the door as instructed.• Carefully remove media if necessary (logs, glass, brick panels, etc.).• Using a vacuum with soft brush attachment, gently remove any dirt, debris, or carbon build up from thelogs, fi rebox, and burner. For glass media, follow the installation instructions for pre-cleaning.• Gently remove any build-up on the pilot assembly including thermopile, thermocouple, flame sensor, andigniter (if equipped).• Inspect all accessible gaskets and replace as required.• If equipped with a blower, access the blower and clean using a soft brush and vacuum.• Re-assemble the various components in reverse order.• Inspect the relief system. The appliance relieves through the main glass door or through the fl aps on thefi rebox top. Ensure they open freely, and close sealed.• Check the gas control valve pilot and Hi / Lo knobs move freely, if equipped. Replace if any stiffness inmovement is experienced.• Check for gas leaks on all gas connections up and downstream from the gas valve including pilot tubeconnections.Clean fl ame sensor using a fine emery cloth or a synthetic scrub pad (such as Scotch-Brite™) to remove anyoxides. Clean the pilot assembly using a vacuum with a soft brush attachment. It is important that the pilotassembly is not painted.note:• Annual maintenance should be performed by a qualified service technician• The fi rebox becomes very hot during operation. Let the appliance cool completely or wear heat resistantgloves before conducting service.• Never vacuum hot embers.• Do not paint the pilot assembly! WARNINGBuff lightly with a clean dry soft cloth to remove accumulated dust or fingerprints. Clean both sides of the glassafter the first 10 hours of operation with an ammonia-free glass cleaner.Thereafter, clean as required. If the glass is not kept clean permanent discoloration and / or blemishes mayresult. Contact you local authorized dealer / distributor for complete cleaning instructions.Razor blades, steel wool, or other metallic objects must not be used on both surfaces of the glass. Doing socan remove a thin layer of metal from the razor blades, steel wool, or other metallic objects that may then bedeposited onto the coating. This can result in a discoloured stain or scratch-like mark. More importantly, this canscratch the glass surface, thereby reducing its strength.Do not operate the appliance with broken glass, as leakage of flue gases may result.Contact your local authorized dealer / distributor for complete cleaning instructions.If the glass should ever crack or break while the fire is burning, do not open the door until the fire is out. Do notoperate the appliance until the glass has been replaced. Contact you local authorized dealer / distributor forreplacement parts. DO NOT SUBSTITUTE MATERIALS.5.1AVinegar-based glass cleaners have demonstrated an ability to provide a clean, streak free glass surface.note:• Do not clean glass when hot! Do not use abrasive cleaners to clean glass.This appliance is factory equipped with 5mm ceramic glass. Use only replacement parts as supplied by theappliance manufacturer. DO NOT SUBSTITUTE MATERIALS.