Napoleon LHD50N Installation And Operating Instructions Manual

Also see for LHD50N: Installation and operating instructions Installation and operating instructions Installation and operating instructions

Contents

Napoleon LHD50N Installation And Operating Instructions Manual Manual pdf 49 page image

49W415-0745 / F / 08.26.13EN9.0 OPERATING INSTRUCTIONSIF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULTCAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.NEVER LEAVE CHILDREN OR OTHER AT RISK INDIVIDUALS ALONE WITH THE APPLIANCE.ALWAYS LIGHT THE PILOT WHETHER FOR THE FIRST TIME OR IF THE GAS SUPPLY HAS RUN OUT WITHTHE GLASS DOOR OPENED OR REMOVED.! WARNINGFOR YOUR SAFETY READ BEFORE LIGHTING:A. This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light by hand.B. Before operating smell all around the appliance area for gas and next to the floor because some gas is heavier thanair and will settle on the floor.C. Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspectthe appliance and replace any part of the control system and any gas control which has been under water.WHAT TO DO IF YOU SMELL GAS:Turn off all gas to the appliance.Open windows.Do not try to light any appliance.Do not touch any electric switch; do not use any phonein your building.LIGHTING INSTRUCTIONSA. Stop! Read the above safety information on this label.B. Remove batteries from transmitter.C. Turn off all electric power to the appliance.D. This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light the pilot byhand.E. Open the glass door.F. Turn manual shutoff valve clockwise to off. Located behind the access panel.G. Wait five (5) minutes to clear out any gas. If you smell gas including near the floor, STOP! Follow “B” in the abovesafety information on this label. If you don’t smell gas go to the next step.H. Turn manual shutoff valve counter-clockwise to on.I. Close the glass door.J. Turn on all electric power to the appliance and re-install batteries into the transmitter.K. Push the “ON” button on the transmitter. You should here an audible beep from the receiverwhich indicates communication. (Refer to Appliance Operations for remote activation).TO TURN OFF GASA. Turn off all electric power to the appliance if service is to be performed.B. Access door inside the firebox must be removed to access the manual shutoff valve.C. If alternate shut-off valve was installed it can be shutoff instead of going through the appliance to accessthe appliance shut off valve.Immediately call your gas supplier from a neighbor'sphone. Follow the gas supplier's instructions.If you cannot reach your gas supplier, call the firedepartment.47.4Ensure that a continuous gas flow is at the burner before installing the door. When lit for the first time, theappliance will emit an odor for a few hours. This is a normal temporary condition caused by the “burn-in” ofpaints and lubricants used in the manufacturing process and will not occur again. After extended periods ofnon-operation such as following a vacation or a warm weather season, the appliance may emit a slight odorfor a few hours. This is caused by dust particles in the heat exchanger burning off. In both cases, open awindow to sufficiently ventilate the room.