Napoleon LHD50N Installation And Operating Instructions Manual

Also see for LHD50N: Installation and operating instructions Installation and operating instructions Installation and operating instructions

Contents

Napoleon LHD50N Installation And Operating Instructions Manual Manual pdf 52 page image

52W415-0745 / F / 08.26.13ENENCAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improperand dangerous operation. Verify proper operation after servicing. This appliance and its venting systemshould be inspected before use and at least annually by a qualified service person. The appliance area mustbe kept clear and free of combustible materials, gasoline or other flammable vapors and liquids. The flow ofcombustion and ventilation air must not be obstructed.A. In order to properly clean the burner and pilot assembly, remove the logs, rocks and/or glass toexpose both assemblies.B. Keep the control compartment, media, burner, air shutter opening and the area surrounding the logsclean by vacuuming or brushing, at least once a year.C. Check to see that all burner ports are burning. Clean out any of the ports which may not be burning orare not burning properly.D. Check to see that the pilot flame is large enough to engulf the flame sensor and/or thermocouple /thermopile as well as reaches the burner.E. Replace the cleaned logs, rocks or glass. Failure to properly position the media may cause carboningwhich can be distributed in the surrounding living area.F. Check to see that the main burner ignites completely on all openings when turned on. A 5 to 10second total light-up period is satisfactory. If ignition takes longer, consult your local authorized dealer /distributor.G. Check that the gasketing on the sides, top and bottom of the door is not broken or missing. Replace ifnecessary.H. If for any reason the vent air intake system is disassembled, re-install and re-seal per the instructionsprovided for the initial installation.40.1MAINTENANCEMAINTENANCEMAINTENANCETURN OFF THE GAS AND ELECTRICAL POWER BEFORE SERVICING THE APPLIANCE.APPLIANCE MAY BE HOT, DO NOT SERVICE UNTIL APPLIANCE HAS COOLED.DO NOT USE ABRASIVE CLEANERS.DO NOT PAINT THE PILOT ASSEMBLY.! WARNING37.1A! WARNINGTHE FIREBOX BECOMES VERY HOT DURING OPERATION. LET THE APPLIANCE COOLCOMPLETELY OR WEAR HEAT RESISTANT GLOVES BEFORE CONDUCTING SERVICE.NEVER VACUUM HOT EMBERS.DO NOT PAINT THE PILOT ASSEMBLY.• This appliance will require maintenance which should be planned on an annual basis.• Service should include cleaning, battery replacement, venting inspection and inspection of the burner,media and firebox. Refer to the door removal section and remove the door as instructed.• Carefully remove media if necessary (logs, glass, brick panels etc).• Using a vacuum with a soft brush attachment, gently remove any dirt, debris or carbon build up from thelogs, firebox and burner. For glass media, follow the installation instructions for pre-cleaning.• Also gently remove any build-up on the pilot assembly including, if equipped; thermopile, thermocouple,flame sensor and igniter. NOTE: The flame sensor may require to be cleaned with an abrasive, suchas a Scotch-Brite pad to remove any oxides. It is important that the pilot assembly is not painted.• Inspect all accessible gaskets and replace as required.• Access the blower, if equipped and clean using a soft brush and vacuum.• Re-assemble the various components in reverse order.• Inspect the relief system. The appliance relieves through the main glass door or through the flaps on thefirebox top. Ensure they open freely, and close sealed.11.0 MAINTENANCE11.1 ANNUAL MAINTENANCE