W415-1596 / 11.25.1533ENC. Align the hole in thebottom of the front leftlog (W135-0563) withthe screw and spaceron the left side of theburner. The middle ofthis log rests against thecharcoal strip.B. Place the charcoalstrip log (W135-0448)on top of the gratealigning the notches inthe charcoal strip withthe grate.A. Place the rear log (W135-0444) on rear bracket,ensure the log is seatedproperly on the rear bracketand located on the centerpin.7.3 LOG PLACEMENTLOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT CHANGE OR MODIFYFROM THE PROPER LOG POSITION, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYEDIGNITION MAY OCCUR.THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.The individual logs can be easily identified by the numbers cast on the underside of each log.Phazer TM logs and glowing embers exclusive to Wolf Steel Ltd., provide a unique and realistic glowing effectthat is different in every installation. Take the time to carefully position the glowing embers for a maximumglowing effect. During the initial use of the appliance, log colours may vary. During the initial use of theappliance the colours will become more uniform as colour pigments burn in during the heat activated curingprocess.! WARNINGD. Align the hole in the bottomof the front right log (W135-0564) with the screw andspacer on the right sideof the burner. The bottomprotrusion should rest alongthe edge of the burner andpulled forward until it restsagainst the charcoal strip.E. Align the holes in thebottom of the rightlog (W135-0447) withthe pins in the rearand front right log.F. Align the hole in thebottom of the left log(W135-0446) with thepin in the rear log. Rest-ing the right side of thelog against the burner.G. Align the hole in the bottom of the front log (W135-0449) with thepin in the charcoal strip. Rest the right side of the log against thefar right grate post.