Napoleon NZ6000-1 Installation And Operating Instructions Manual

Also see for NZ6000-1: Installation and operating instructions Installation and operation manual Installation and operation instruction Installation and operating instructions

Contents

W415-1501 / 05.15.1537EN8.3 FIRE EXTINGUISHERS AND SMOKE DETECTORS91.1AAll homes with a solid fuel burning appliance should have at least one fire extinguisher in a central location,known to all, at least one smoke detector and carbon monoxide (CO) detector in the room containing theappliance. If the smoke detector sounds an alarm, correct the cause but do not de-activate or relocate thesmoke detector. If the carbon monoxide detector sounds an alarm, immediately vent the area, evacuate andcall your local fi re department.8.4 FUEL LOADING AND BURN CYCLE92.1AThe bricks will be nearly all white and the glass mostly clear. The whiteness of the bricks and the cleanness of theglass are good indicators of your operating efficiency.Not enough heat is produced when only one or two pieces of wood are burned.A minimum of three pieces are needed to encase a bed of coals that sustains the fire. Loosely stacked wood burnsquicker than a tightly packed load.Wood burns in cycles rather than giving a steady output of heat. It is best to plan these cycles around yourhousehold routine so that only enough coals are left to start the next load. In the evening load your appliance atleast a half-hour before bed to ensure the fire is hot enough to close the draft control for an overnight burn.Burn only dry seasoned wood. It produces more heat and less soot or creosote. Do not burn ocean beach wood. Itssalt content can be corrosive to the metal.INSUFFICIENT FIREWOOD SUFFICIENT FIREWOOD! WARNINGBURN WOOD BEHIND THE LOG RETAINER DIRECTLY ON THE FIREBRICKS.DO NOT USE ELEVATED GRATE OR OTHERWISE RAISE THE FIRE.DO NOT STORE WOOD WITHIN APPLIANCE INSTALLATION CLEARANCES OR WITHIN THE SPACEREQUIRED FOR RE-FUELING AND ASH REMOVAL.