Setting Originals292Setting one original at a time(SADF) modeImportantr Hold the document from the frontwhen setting it. If your hand cov-ers the internal sensor, it will notoperate correctly and the originalcould be damaged.r When setting pages of documents1 page at a time in the ADF usingAuto Paper Select and Auto Re-duce/Enlarge, these featuresadapt to the size of the scannedoriginal.A Set one original face up into thedocument feeder. Then, press the{{{{Start}}}} key.The Auto Feed indicator is lit.B Set the next original while theAuto Feed indicator is lit.The second and subsequent origi-nals can be fed automatically with-out pressing the {Start} key.Noter You can adjust the time the ma-chine waits before being readyfor the next original. See “SADFAuto Reset” in ⇒ P.82 “2. Input/Output”.Setting Originals When AutoPaper Select CannotRecognize the SizeWhen you wish to use Auto Reduce/Enlarge when setting non-standardsize documents in the ADF, specifythe size of your original using the fol-lowing procedure.Importantr Be sure to press the {Clear Modes}key after copying non-standardsize originals to clear any settings.Not taking this precaution couldresult in damage to originals set inthe ADF.Limitationr You cannot specify the originalsize when using Auto Paper Select.r Acceptable Document Sizes• Vertical: 105–297mm(4.1"–11.7")• Horizontal: 128–1,260mm(5.0"–17.0")A Set the aligned originals face upinto the document feeder.B Adjust the guide to the originalsize.
