NateoSante Eolis Series Operating Manual

Also see for EOLIS 1200: Operating manual Operating manual

Contents

NateoSante Eolis Series Operating Manual Manual pdf 23 page image

replAcing FilterSWhen should I replace the pre-filter?the lifespan of the pre-filter depends on the environment in which it is used. the pre-filter should be replacedregularly (every 3 to 4 months on average) in order to limit filter clogging. It is essential that you monitor thepre-filter regularly to check its status.How do I replace the pre-filter?1 • turn off your unit.2 • Open the front cover and remove the filters using the 2 tabs designed for this purpose.3 • Remove the used pre-filter from the filters to replace it with a new one.4 • Put the filters back in, with tabs facing out.5 • Close the front cover. Make sure the front cover is positioned correctly, to ensure that your unit will oper-ate correctly.6 • turn on the unit. the new filter is tested by the “filter test” system. “New filter?”: You can say NO (only forchanging built-in filters).When should I replace the filters?the lifespan of the filters depends on how the unit is used and the concentration of pollutants in the air (be-tween 10 and 12 months if the unit operates 24/7). For an instant status of your filters’ conditions, see the realfilter service indicator (see page 19). It is sometimes necessary to replace the filter after it has been used forde-pollution after construction or prolonged use in a very polluted environment (thick smoke, strong persis-tent odours, etc.)Do not clean the filter, place it in water or vacuum it: this could cause changes in the fibres or cartridges, lead-ing to poor operation or reduced efficiency of your air manager.If the alert icon appears on the control screen, a message indicating the advanced use status will appear.You will receive an alert when your filters are 80% clogged. Depending on the use level of your filters, your unitwill alert you as follows:• 80% used filter: “Plan to change filters”• 100% used filter: “Purifier OFF - Pending filter change”If the filter reaches 100% saturation, the unit will stop working to prevent damage to the motor. It will startworking again as soon as you have changed the filters.How do I replace the filters?1 • do not tUrn oFF yoUr Unit.2 • Open the front cover and remove the filters using the 2 tabs designed for this purpose.3 • Remove the new filters from their packaging, making sure not to damage them.4 • Put the filters back in, with tabs facing out.5 • Close the front cover. Make sure the front cover is positioned correctly, to ensure that your unit will oper-ate correctly.6 • the new filters are tested by the “filter test” system. “New filter?”: you can say YES. If the front cover isopen but you have not changed the filters, you can say NO or ignore the message.replAcing Uv lAmpSWhen should i replace the Uv lamps?the UV lamps will wear differently depending on how often you activate the UV LAMP (or photocatalysis)feature. the lifespan for a UV lamp is generally 1 to 2 years.how do i replace the Uv lamps?1 • turn off your unit.2 • Open the front cover and remove the filters to reach the UV lamps.3 • to remove or replace a lamp, pull it gently and vertically upwards.4 • Remove the new lamps from their packaging taking care not to damage them and place them in the unitwhere the old lamps were.5 • then put the filters back in, with tabs facing out.6 • Close the front cover. Make sure the front cover is positioned correctly, to ensure that your unit will oper-ate correctly. Your air manager is ready to operate again.23 - EOLIS Air Manager 600 600 S 1200 1200 S