24 - EOLIS Air Manager 600 600 S 1200 1200 ScleAning the Air mAnAgerClean your unit with a soft cloth that is slightly damp to remove dust. Make sure to follow the safety instructions (seep.17).cleAning the SenSorSYour air manager has 2 sensors: one particle sensor and one VOC (Volatile Organic Compounds) sensor.these 2 sensors measure air quality in real time. For optimal operation, it is necessary to clean these sensorsat least once per month.• turn off your unit.• Open the front cover. the sensors are located above the filters, under the flap.• Using a damp cotton bud, clean the sensors gently and then let them dry.• Close the front cover. Make sure the front cover is positioned correctly, to ensure that your unitwill operate correctly. Your unit is ready to operate again.troUbleShooting helpproblem(s) Solution(s)the unit is no longer operating.- Check the power plug- Make sure the front cover was closed correctly- Your filters may be saturated: make sure the “Pending filter change” mes-sage does not appear in “Errors”- Make sure the Planner is not set to OFF for a certain amount of time (Set-tings - Planner ON/OFF).the unit will not turn off - Unplug your unit and wait a few minutes before turning it back on- Make sure that Demo Mode is not active (Settings - Demo Mode ON/OFF)You feel cool air coming from yourunitCool air from the ground level is drawn up, filtered, and then propelled out.this can make the air feel cool.the error symbol appears on themain screenAn irregularity has been detected by EOLIS Air Manager. Click on the sym-bol to display more details.I can’t activate the UV lamp(s) and/orthe Ozone featureUV lamp(s) come in models EOLIS Air Manager 600, 600 S, 1200, 1200 S.Ozone comes in models 600 S and 1200 S.My unit changes fan speeds- Make sure that Active Mode is not on (smart mode)- Make sure you have not programmed Active Mode or a set fan speed in theplannerI activated Active mode, and thedevice is showing an abnormallyhigh level of pollution (PM2.5 and/or VOC), but the air purifier is notcontinually operating at maximumspeedIn Active mode, EOLIS Air Manager adapts its speed to the level of pollution.If the level of pollution is high, EOLIS Air Manager will go up to maximumspeed. however, if the level persists, it will systematically reduce its speedregularly for your acoustic comfort.I changed the filters, but the unit isnot detecting themOpen the front cover to run an immediate filter test. Wait for the message“Door open. New filter?” and confirm. You can now close the front cover.Make sure that the new filters are NatéoSanté certified.this message appears explanations / Actions“hold down for 3s”this message appears when you have pressed on the following icons: Nightmode, Childproof, On/Off. to activate these features, hold down the icon for3 seconds.