National Instruments 9512 C Series Getting Started

Also see for 9512 C Series: Getting started

Contents

Getting Started with NI SMD-7611/7612 and NI 9512 Modules | © National Instruments | 13Step 12: Power on the Drive and Verify ConnectionsAfter all hardware connections have been made complete the following steps to confirm thehardware setup.1. Turn on all power supplies.2. Verify that the Drive Status LED on the NI SMD-7611/7612 flashes or is solid green.Figure 12 shows the location of the Drive Status LED.Figure 12. Drive Status LED LocationTable 4. NI SMD-7612 Motor Selection Switch SettingsSwitchSetting Motor WiringDrive CurrentAmps, peak ofsineHoldingTorque,oz-inRotorInertiag-cm 20reserved for custom configurations123 ST23-8 parallel 6 354 7504 ST23-1 parallel 3.4 76.6 1205 ST23-4 parallel 5 177 3006 ST23-6 parallel 5 264 4807 ST24-1 4 leads 3.36 123 2808 ST24-2 4 leads 4.8 177 4509 ST24-3 4 leads 4.8 354 900A ST34-2 parallel 8 507 1400B ST34-5 parallel 8 965 2680C ST34-8 parallel 8 1439 4000D ST34-1 parallel 7.56 396 1100E ST34-4 parallel 7.56 849 18501 2 3 4 5 6 7 8Status LEDs