National Instruments FD-11613 User Manual

Also see for FD-11613: Manual Quick start

National Instruments FD-11613 User Manual Manual pdf 12 page image

Refer to the FD-11613 Specifications for information about the power connectors, powerrequirements, and current limits of your FieldDAQ device.Cap the power connectors when not in use.Power ConnectorsThe following figure shows the pinout of the Power IN connector.Figure 7. Power Connector PinoutAux1CVChassis Ground ( )Aux2 23451Table 3. Signal DescriptionsPin Number Signal Description1 V Positive voltage line2 Aux2 Optional line for powering non-FieldDAQ devices3 C Common. Negative voltage line4 Aux1 Optional line for powering non-FieldDAQ devices5 — Chassis GroundPower LEDThe green POWER LED on the front panel identifies when the device is powered.Table 4. LED State/Device StatusLED State Device StatusOn Device is receiving adequate power for its tasks.Off Device is unpowered or receiving inadequate power.Wiring External Power to the FieldDAQ DeviceComplete the following steps to connect a power source to the FieldDAQ device.1. Verify the power source is turned off.12 | ni.com | FD-11613 User Guide