2-6 | ni.comChapter 2 DAQ System Overview68-Pin BNC AccessoriesYou can use your 68-pin cable to connect your DAQ device to the following BNC accessories:• BNC-2110—Provides BNC connectivity to all analog signals, some digital signals, andspring terminals for other digital signals• BNC-2111—Provides BNC connectivity to 16 single-ended analog input signals,two analog output signals, five DIO/PFI signals, and the external reference voltage foranalog output• BNC-2120—Similar to the BNC-2110, and also has a built-in function generator,quadrature encoder, temperature reference, and thermocouple connector• BNC-2090A, BNC-2090—Desktop/rack-mountable device with 22 BNCs for connectinganalog, digital, and timing signals• BNC-2115—(NI 6225/6255 Devices) Provides BNC connectivity to 24 of the differential(48 single ended) analog input signals on Connector 1 of NI 6225/6255 devices68-Pin Screw Terminal AccessoriesYou can use your 68-pin cable to connect your DAQ device to the following screw terminalaccessories:• SCB-68A, SCB-68—Shielded connector block with temperature sensor• TB-27061 —Front panel mounted terminal block for PXI/PXI Express M Series devices• SCC-68—I/O connector block with screw terminals, general breadboard area, busterminals, and four expansion slots for SCC signal conditioning modules.• TBX-68—DIN rail-mountable connector block• CB-68LP, CB-68LPR—Unshielded connector blocksRTSI CablesUse RTSI bus cables to connect timing and synchronization signals among PCI/PCI Expressdevices, such as X Series, E Series, CAN, and other measurement, vision, and motion devices.Since PXI devices use PXI backplane signals for timing and synchronization, no cables arerequired.SCC Carriers and AccessoriesSCC provides portable, modular signal conditioning to your DAQ system. Use your 68-pin cableto connect your device/module to an SCC module carrier, such as the following:• SCC-68—68-pin terminal block with SCC expansion slots• SC-2345—Shielded carrier for up to 20 SCC modules• SC-2350—Shielded SCC carrier for TEDS sensors1 TB-2706 uses Connector 0 of your PXI/PXI Express module, therefore does not require a cable. After aTB-2706 is installed, Connector 1 cannot be used.Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
