National Instruments NI 1712 User Manual

Also see for NI 1712: User manual

Contents

National Instruments NI 1712 User Manual Manual pdf 23 page image

© National Instruments | 2-3NI 17xx User ManualInstall Software on the NI Smart CameraComplete the following steps to install software from the development computer to the NI 17xxSmart Camera.1. In the Remote Target Configuration Wizard, enable the Update Target Softwarecheckbox.2. Click the Browse button next to the Software Image to Install on the Target control.3. Navigate to the Vision Builder AI software image you want to use, and click OK. Softwareimages provided by National Instruments are installed to the Builder AI>\RT Images directory, where Builder AI> is the location where VisionBuilder AI is installed.4. Click OK to apply the IP configuration settings and download software to the device.5. Click OK to close the Remote Target Configuration Successful dialog box.Acquire an Image with Vision Builder AIComplete the following steps to acquire an image using Vision Builder AI.1. On the Vision Builder AI welcome screen, select the NI 17xx Smart Camera in the list oftargets.2. Click Acquire Image (Smart Camera) Example. The image acquisition example opensin the Vision Builder AI Configuration Interface.3. Click the Run Inspection Once button to acquire a single image.4. In the State Configuration Window, select the Acquire Image (Smart Camera) step.5. Click the Edit Step button. The property page for the step opens.6. Use the controls on the Main, Trigger, Lighting, Calibration or Advanced tabs toconfigure additional settings for your application.7. Click OK to save the step configuration.The NI 17xx Smart Camera is now configured and acquiring images. Use Vision Builder AI toadd and configure additional inspection steps to create your application. Refer to the RelatedDocumentation section in the introduction to this manual for a list of documentation and otherresources to help you set up and use the NI 17xx Smart Camera in an application.