National Instruments PXIe-4302 User Manual And Specifications

Also see for PXIe-4302: User manual CALIBRATION PROCEDURE

Contents

National Instruments PXIe-4302 User Manual And Specifications Manual pdf 4 page image

4 | ni.com | NI PXIe-4302/4303 and TB-4302/4302CUnpack and Install the ModuleRemove the packaging and inspect the module. Contact NI if the module is damaged. Do notinstall a damaged module.Caution The module is static sensitive. Always properly ground yourself and theequipment when handling or connecting to the module.Complete the following steps to install the NI PXIe-4302/4303 module while referring toFigures 1 and 2:Note To maintain forced air cooling in the PXIe system, refer to the MaintainForced-Air Cooling Note to Users.1. Plug in your chassis before installing the NI PXIe-4302/4303. The power cord grounds thechassis and protects it from electrical damage while you install the module.2. Make sure the chassis is powered off.Caution To protect yourself, the chassis, and the NI PXIe-4302/4303 fromelectrical hazards, leave the chassis powered off until you finish installing theNI PXIe-4302/4303 module.3. Touch a metal part on the chassis to discharge any accumulated static electricity.4. Identify a supported PXI Express slot in the chassis. NI PXIe-4302/4303 modules can beplaced only in PXI Express Peripheral slots, PXI Express Hybrid Peripheral slots, and PXIExpress System Timing slots. Refer to the chassis documentation for details.Figure 1. Symbols for PXI Express/ PXI Express Hybrid/ PXI Slots5. Remove the filler panel, and touch any metal part of the chassis to discharge staticelectricity.6. Place the module edges into the module guides at the top and bottom of the slot.Caution When installing the module, make sure both edges are positioned insidethe guides and that the module components do not come into contact with adjacentmodules.1 PXI Express System Controller Slot2 PXI Peripheral Slot3 PXI Express Hybrid Peripheral Slot4 PXI Express System Timing SlotNI PXIe-1062Q1 2 3 4