National Instruments SCXI-1160 User Manual

Also see for SCXI-1160: Getting started Getting started guide Getting started guide Instructions for safe use

Contents

National Instruments SCXI-1160 User Manual Manual pdf 81 page image

SCXI-1160 Cabling Appendix ESCXI-1160 User Manual E-10 © National Instruments CorporationSCXI-1348 InstallationFollow these steps to install the SCXI-1348:1. Make sure that the computer and the SCXI chassis are turned off.2. Install the SCXI module to which the SCXI-1348 will connect.3. Connect one end of the ribbon cable to the adapter board rear connector.4. Plug the adapter board front connector onto the module rear signal connector. A corner ofthe adapter board will enter the upper board guide of the chassis.5. Screw the rear panel to the threaded strips in the rear of the chassis.6. Connect the loose end of the ribbon cable to the DIO-32F I/O connector.Check the installation.SCXI-1180 Feedthrough PanelThe SCXI-1180 feedthrough panel provides front panel access to the signals of any dataacquisition board that uses a 50-pin I/O connector. The SCXI-1180 consists of a front panel witha 50-pin male front panel connector that occupies one slot in the SCXI chassis, and a ribboncable with a female rear connector and a male breakout connector. You can attach the rearconnector to the male breakout connector of an SCXI-1340, SCXI-1341, SCXI-1342,SCXI-1344, or SCXI-1351 in the adjacent slot. The breakout connector further extends thecabling scheme. The front panel connector has the feedthrough connection. You can attach anSCXI-1302 terminal block to the front panel connector for simple screw terminal connections. Arear filler panel that shields and protects the interior of the SCXI chassis is also included.SCXI-1180 InstallationInstall the SCXI-1180 to the right of a slot that has an SCXI-1340, SCXI-1341, SCXI-1342, orSCXI-1344 cable assembly or an SCXI-1351 slot extender in its rear connector space.Follow these steps to install the SCXI-1180:1. Make sure that the computer and the SCXI chassis are turned off.2. Remove the front filler panel of the slot where you want to insert the SCXI-1180.3. Thread the rear connector through the front of the chassis to the rear of the chassis. Attachthe rear connector to the breakout connector of the adjacent cable assembly or slot extender,as shown in Figure E-3.4. Screw in the rear panel to the threaded strip in the rear of the chassis.5. Screw the front panel into the front threaded strip, as shown in Figure E-4.Check the installation.