8.4.5 Assignments for KnobsFor the Knobs, the Type menu offers the entries Control Change and Program Change. Depend-ing on the selected entry, the further available options differ subsequently. The following tabledetails the different combinations of options:Type Menu Value Mode Menu Range Number StepControl Change Absolute From 0-126 / To1-127Number(0-127)Relative Step (-32 to31)Relative (Offset) Step (-32 to31)Program Change From 0-126 / To1-127Mode Menu Values for KnobsFor the type Control Change, a Mode menu allows you to select between three operatingmodes:▪ Absolute: In this mode the control element sends absolute values. The Range From, To, andResolution parameters are the same as for the other message types (see above).▪ Relative: In this mode the sent message is in a +1/-1 fashion — actually 1/127, which isthen understood by the target software as +1/-1 in that case. This allows the control ele-ment to set the new Control Change value relatively to its current value. Two parametersare available:◦ Step: Defines the increment to use. Increase the Step value to trigger greater jumps inthe target parameter value. If you choose a negative value for Step, the control will beinverted.MIDI CommunicationUsing the MIDI Assignment EditorKOMPLETE KONTROL - Manual - 93
