Nautel NV20LT Installation Manual

Nautel NV20LT Installation Manual Manual pdf 39 page image

NV20LT/NV15LT INSTALLATION MANUAL INSTALLING PROGRAM INPUTSVERSION 4.0 2018-02-26 PAGE 2.7.1SECTION 2.7: INSTALLING PROGRAM INPUTSThis section describes how to route program input wiring to the NV20LT/NV15LT’s exciter(s).Planning Complete?1. Make sure you have read and fully understood the program input options described in the NV20LT/NV15LT Pre-installation Manual before proceeding.2. Make sure the program input wires are long enough to allow routing through the top of thetransmitter cabinet and down to the rear panel of the controller and exciter (if applicable).3. If you ordered the optional Exciter Upgrade kit, make sure it is installed (see “Upgrading to DualExciter” on page 2.3.5). The transmitter is factory configured with a single exciter - within thecontroller (A4).4. If you ordered the optional Orban Inside Audio Processor kit for one or both exciters, as applicable,make sure it is installed (see “Installing the Orban Inside Card” on page 2.3.8). The transmitter’sexciters are factory configured with no Orban Inside audio processor card.Routing CablesRoute the desired analog and digital program input cables to the back of the NV20LT/NV15LT’scontroller and optional exciter.1. Route all program input cables from their audio sources to the top of the transmitter. If you areusing dual exciters, you will need two sets of program inputs - one for each exciter.2. Get two ferrite toroids (Nautel Part # LXP38, 19 mm inner diameter) from the ancillary kit for eachexciter installed. The controller’s integral exciter is exciter A. The optional exciter, if installed, isexciter B.3. Pass all program input cables through the ferrite toroids obtained in Step 2. If practical, wiresshould pass through a minimum of two times (two turns) (see Figure 2.7.1 on page 2.7.2). Anentrance is provided at the top of the transmitter to accept program input wiring. Position theferrite toroids just outside, or just inside, the program input entry hole.4. Punch the appropriate size hole in the program input entry plate (see Figure 2.7.2 on page 2.7.3): Remove the program input entry plate from the top of the transmitter. It is secured using fourM4 screws and has a pre-cut, centered 1/4-inch diameter hole.