Navien Modbus/BACnet Gateway Installation & Operation Manual
                                       | |
Contents
| 
17NETWORK SETTINGS7.2.3 Common SettingsFrom the FS-GUI Network Settings landing page, click on theCommon tab.Note Default is Primary Connection is Ethernet.To change the primary connection when both Ethernet and Wi-FiClient connections are available:1. Select the desired option from the drop-down menu on theright.2. Click Update Common Settings, then click on System Restart torestart the gateway and activate the new settings.Note If using Wi-Fi Client and not Ethernet, changePrimary Connection to Wi-Fi.Figure 28: FS-GUI Common Network SettingsNote The fields below the update button show the settingsas they were set in the IP Settings or Wi-Fi Client pages.They are not editable on the Common page.Figure 27: FS-GUI Wi-Fi Client Network SettingsWi-Fi Client Fields DefinitionConnection Status Status of connectionMAC Address,BSSID, ChannelWi-Fi Client MAC Address, BSSID, andChannelTx/Rx Msgs Number of transmitted and receivedmessagesTx/Rx MsgsDropped Number of unanswered Tx or Rx messagesPairwise Cipher Type of encryption used for unicast trafficGroup Cipher Identifies the type of encryption used formulticast / broadcast trafficKey Mgmt Encryption typeLink Connection speedSignal Level Signal level in dBm (see Appendix A.6) |
Related manuals for Navien Modbus/BACnet Gateway
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine