User's manual MobileNavigator | 5- 8 - Installing the software2.1 Installing the software2.1.1 Inserting the memory card into the deviceInsert the memorycard into the device…Before using MobileNavigator you must insert the memory cardcontaining the cartographic data into the device.1. Unpack the memory card carefully. Pay attention not to touchcontacts and not to make them dirty.2. Hold the memory card as shown below (label up, cut cornerbottom right). Insert the memory card into the respective sloton the top of the device. It should snap in.Note: The memory card must stay inserted in the device whileyou are using the navigation system. If you remove the cardwhile using the system, it executes a soft reset and prompts youto insert the memory card.2.1.2 Installing the navigation softwareInstall the navigationsoftware...1. Use the pen to slide the main switch on the bottom of thedevice to ON.The brand logo is being displayed for a short time. Theinstallation procedure starts automatically. After a fewseconds, the registration wizard starts which guides youthrough the registration procedure.Note: Depending on the battery charging state, it may happenthat you have to charge the device for a while before theinstallation may be executed.
