Navman Qube 2.5 Installation Manual

Contents

Navman Qube 2.5 Installation Manual Manual pdf 5 page image

Qube 2.5 | Installation Manual73 Quick Install – 4-Wire Basic Tracking3.1 Power ConnectionWire Colour Function DescriptionRed +12/24V Main Power Connection. This connection must be fusedBrown Ignition Positive input from vehicle when the key is in the IGNITIONposition (not the accessory position). This signal must remainon DURING starting of the vehicle. This connection must befusedBlack GND Vehicle ground / chassis connectionOrange Backup Battery Optional external battery back upIMPORTANT NOTICEPlease individually insulate any bare ends that are not connected.Connect to a fused supply.••3.2 Recommended MountingUnder the driver or passenger’s seatIn or under the dashIn the boot / truck areaWhere it is not excessively hotWhere it is dryWhere there is not excessive vibrationShould allow MDT/PDT connectionShould allow the diagnostics LED’s to be seenShould allow sufficient clearance to plug and unplug while mounted3.3 Status LED IndicatorsLED Display State Normal Operation DescriptionPWR On P Power ON, Unit awakeSlow Blink Sleep modeOff No Power – the Qube 2.5 should alwaysbe poweredGPS On P GPS fi xOff No GPS fixCell On P Data connection to cellular networkOff No data connection•••••••••Qube 2.5 Installation Manual.indd 7Qube 2.5 Installation Manual.indd 7 7/8/08 12:08:58 PM7/8/08 12:08:58 PM