Naxa NCD-694 Instruction Manual

Also see for NCD-694: User manual

Contents

Naxa NCD-694 Instruction Manual Manual pdf 10 page image

2. Common Operation1. To turn on/off the unitUnder power off mode, press the POWER button to turn on the unit.Under power on mode, long press the POWER button on the front panel orbriefly press the POWER button on the remote control to turn off the unit.2. To select function modePress the MODE button to select TUNER, DISC(After inserting a disc), USB(After inserting a USB storage), Card(After inserting a MMC or SD card) orAUX mode.3. To adjust sound levelRotate the VOL knob on the front panel or press or hold the + or - button onthe remote control to directly adjust the volume level.4. To mute soundPress the MUTE button on the remote control to turn on/off MUTE mode.Briefly pressing the POWER button on the front panel also can turn on/offMUTE mode.In MUTE mode, the MUTE mode can be released by pressing the followingbuttons: MUTE, VOL or +/-, SEL, MODE.5. To display and adjust the clock timePress the CLK button to display clock time on the small monitor of the frontpanel.Then long press the CLK button to change the color of the hour of the clock,then rotate the VOL knob on the front panel or press the + or - button on theremote control to adjust the hour; and then briefly press the SEL button tochange the color of the minute of the clock, then rotate the VOL knob on thefront panel or press the + or - button on the remote control to adjust theminute.6. To select a preset EQ modePress the EQ button to select the preset music equalizer curves: POP, ROCK,CLAS, FLAT . The sound effect will be changed.It is for adjusting the hue of the video output.It is for adjusting the saturation of the video output.It is for adjusting the sharpness of the video output.It is for selecting your desired sound effect when there is not central speakerand sub-woofer. There are 3 mode: LT/RT, STEREO, VSS.LT/RT: When playing a disc with PRO LOGIC Dolby stereo effect, choose theitem, so it will output audio signal with vivid theatre effect.STEREO: If you choose the item, when outputting audio signal with 5.1 channels,it will output the left and right channels of signal ; when outputting audio signalwith 2 channels, it will output the common 2 channels of stereo signal.VSS: If you choose the item, when playing a disc recorded with 5.1 channels,the main channel speakers can output audio signal with VSS effect.It is for selecting audio output modeLINE OUT: It can linearly compress the audio signal. So the volume level is lower.RF REMOD: It can make the volume level higher.After selecting the compression mode of LINE OUT, set the item, so you canadjust the linear compression ratio. If you set it to be FULL, the Peak-to-Peakvalue of the audio signal is the minimum; if you set it to be OFF, the Peak-to-Peak value is the maximum.It is for selecting a desired audio output mode for the left and right ways of signal.There are 4 modes in all as follows: STEREO, MONO L, MONO R, MIX MONO.HUESATURATIONSHARPNESS5.19.5 SPEAKER SETUP5.l9.6 DIGITAL SETUPOP MODEDYNAMIC RANGEDUAL MONOSPEAKER SETUPDOWNMIXDIGITAL SETUPOP MODEDYNAMIC RANGEDUAL MONODOWNMIXPDF created with FinePrint pdfFactory trial version http://www.pdffactory.com