20© by NECTA VENDING SOLUTIONS SpA 09-2003 228 00INITIALISINGWhen the “Initialising” function is displayed the vendingmachine can be initialized restoring all default data.This function should be used if there is a memory dataerror or when the EPROM is replaced.All statistic information will be reset.Press confirm button “ ” and the display will indicate themessage “Confirm?”. Press the button “ ” again to displaythe first variable parameter to define the machine configu-ration.The available options (blinking) can be scrolled with the“ ” and “ ” buttons, the selection is confirmed with button“ ” and the next parameter is presented. When pressingbutton “ ” after the last parameter the display will showthe message “Working” for a few seconds and the ma-chine is initialised.The parameters are as follows:“Machine type” C - EspressoI - Instant“Country” Type of doses to beused for the selections“Layout” Layout of containers andselection menu from theavailable ones“Tank” Water supply from the mainsor from a tankSETTING THE MACHINE CODEWhen the “Machine code” function is displayed the iden-tification code number of the machine can be changed(from the default 0000 to 9999).Press the confirm button “ ” and the current code numberis displayed; then press the change button “ ” and the firstdigit will start blinking.The value of the blinking digit can be increased ordecreased with the “ ” and “ ” buttons.When pressing the confirm button “ ”, the blinking digitwill take on the displayed value and the next digit startsblinking.MACHINE CONFIGURATIONWhen the “Machine config” function is displayed, themachine configuration can be changed, and namely:- water supply from the mains (Tank OFF) / internaltank (Tank ON)- presence of warning device for full liquid wastecontainer (equipped cabinet ON)- fast cycles ON / OFF (see following paragraph)- coffee tray ON / OFFPress the confirm button “ ” to display the current status;when pressing the change button “ ” the status startsblinking and can be changed with the “ ” and “ ” buttons.IMPORTANT NOTICE!!!When the machine is initialised, the configuration willtake on the default values: “Water supply from themains/without full waste container warning device/fast cycles ON”.AFTER INITIALISING THE MACHINE MUST BERECONFIGURED.