Necta Colibri Installation, Use And Maintenance Handbook

Also see for Colibri: Service manual Instructions for installation, use and maintenance manual Installation - use - maintenance

Necta Colibri Installation, Use And Maintenance Handbook Manual pdf 22 page image

18© by NECTA VENDING SOLUTIONS SpA 01-2003 197 00PROGRAMMING THE BASIC COINAND THE DECIMAL POINTWhen the “Basic coin / DP” (basic coin value) function fromthe “programming” menu is displayed, the value of thebasic coin as well as the position of the decimal point canbe modified.Press the confirm button “ ” from the “programming”menu to display the current value of the basic coin.Using the “ ” and “ ” buttons, the value of the basic coinand the number of the decimal point position “dP” aredisplayed alternately, i.e:0 decimal point disabled1 XXX.X2 XX.XX3 X.XXXPress the change button “ ”, these values will startblinking and can then be modified as necessary.PAYMENT SYSTEMSWhen the “Payment system” function is displayed, it ispossible to define which payment system with Executivecommunication protocol to use, selecting among:ValidatorTotalizerExecutive standardExecutive Price HoldingExecutive UKEYExecutive ECSIn order to install payment systems different from avalidator or cashless system, special kits must beused.The payment systems must be housed in the cabinet(optional).PROGRAMMING THE VALIDATORIf the selected payment system is a validator, its operatingparameters must be defined.CREDIT CONTROLIt is possible to decide whether any excess credit paid isto be cashed or made available to the user.OPERATING VOLTAGEAccording to the type of validator it necessary to select theoperating voltage, 12 V or 24 V.VALIDATOR LINESWhen the “Validat. Lines” (line setting) function is dis-played, the value of the 6 validator coin lines can bechanged.The value of the lines is indicated as number of basiccoins.Press the confirm button “ ” from the “programming”menu to access the line list, which can be scrolled with the“ ” and “ ” buttons.When pressing correction button “ ”, this value will startblinking and can be modified as necessary.INITIALISINGWhen the “Initialising” function is displayed the vendingmachine can be initialized restoring all default data.This function should be used if there is a memory dataerror or when the EPROM is replaced.All statistic information will be reset.Press confirm button “ ” and the display will indicate themessage “Confirm?”. Press the button “ ” again to displaythe first variable parameter to define the machine configu-ration.The available options (blinking) can be scrolled with the“ ” and “ ” buttons, the selection is confirmed with button“ ” and the next parameter is presented. When pressingbutton “ ” after the last parameter the display will show themessage “Working” for a few seconds and the machine isinitialised.The parameters are as follows:“Machine type” C - EspressoI - Instant“Country” Type of doses to beused for the selections“Layout” Layout of containers andselection menu from theavailable ones“Tank” Water supply from the mainsor from a tankSETTING THE MACHINE CODEWhen the “Machine code” function is displayed the iden-tification code number of the machine can be changed(from the default 0000 to 9999).Press the confirm button “ ” and the current code numberis displayed; then press the correction button “ ” and thefirst digit will start blinking.The value of the blinking digit can be increased or de-creased with the “ ” and “ ” buttons.When pressing the confirm button “ ”, the blinking digitwill take on the displayed value and the next digit startsblinking.