NeoDen 7 User Manual

NeoDen 7 User Manual Manual pdf 20 page image

Hangzhou NeoDen Technology Co.,Ltd.16② The way about how to generate the circle panel when the component number is doublenumber: the project and rectangle of the “component type “are the same, we know it has 24components by observation, the default angle is 0 here, input this value on your own. Becauseif the total component is double number, we only need to find two symmetry to align. Click togenerate the 24 components coordinate in the circle panel.起元器Figure (2.1.3.2-6)③The way about how to mass generate the circle panel when the component number issingle number: item in the type of components is the same as mentioned above, the circlepanel is shown as figure(2.1.3.2-6), after observing the panel, we know it has 9components , because the final number of components is single, it is better to find 3components that are isosceles triangle, and then align the coordinates of those three pointsin turn. Click to generate 9 components’ coordinate in circle panel.起始点元器件2.1.4.2 Secondary editing of componentsFunction: add or alter for the information of components based on exist programmingProcedure: firstly, enter into the program edit page, see figure (2.1.4.2):Put the PCB board into rail which is corresponding with programming, click the “feed” in theaccess setting area, confirm the PCB at the designated place, then click “transform intomachine’s current coordinate” and confirm it, at this time, the machine will automatically scanthe fiducial and transform all existing components’ information into current coordinateInitialpointComponentpoint 2InitialpointComponent point 2point 3