NetComm Wireless NTC-3000-01 User Manual

Also see for NTC-3000-01: Quick start guide

NetComm Wireless NTC-3000-01 User Manual Manual pdf 56 page image

NTC 3000 Series – M2M Serial Modem56 www.netcommwireless.comProduct handlingYou alone are responsible for how you use your device and any consequences of its use.You must always switch off your device wherever the use of a mobile phone is prohibited. Do not use the device without the clip-on covers attached, and do not remove or change thecovers while using the device. Use of your device is subject to safety measures designed to protect users and their environment.Always treat your device and its accessories with care and keep it in a clean and dust-free place.Do not expose your device or its accessories to open flames or lit tobacco products.Do not expose your device or its accessories to liquid, moisture or high humidity.Do not drop, throw or try to bend your device or its accessories.Do not use harsh chemicals, cleaning solvents, or aerosols to clean the device or its accessories.Do not paint your device or its accessories.Do not attempt to disassemble your device or its accessories, only authorised personnel must do so.Do not use or install this product in extremely hot or cold areas. Ensure that the device is installed in an area where the temperature is within the supported operating temperaturerange (-20°C to 70°C)Do not use your device in an enclosed environment or where heat dissipation is poor. Prolonged use in such space may cause excessive heat and raise ambient temperature, whichwill lead to automatic shutdown of your device or the disconnection of the mobile network connection for your safety. To use your device normally again after such shutdown, cool it ina well-ventilated place before turning it on.Please check local regulations for disposal of electronic products.Do not operate the device where ventilation is restrictedInstallation and configuration should be performed by trained personnel only.Do not use or install this product near water to avoid fire or shock hazard. Avoid exposing the equipment to rain or damp areas.Arrange power and Ethernet cables in a manner such that they are not likely to be stepped on or have items placed on them.Ensure that the voltage and rated current of the power source match the requirements of the device. Do not connect the device to an inappropriate power source.Small childrenDo not leave your device and its accessories within the reach of small children or allow them to play with it.They could hurt themselves or others, or could accidentally damage the device.Your device contains small parts with sharp edges that may cause an injury or which could become detached and create a choking hazard.Emergency situationsThis device, like any wireless device, operates using radio signals, which cannot guarantee connection in all conditions. Therefore, you must never rely solely on any wireless devicefor emergency communications.Device heatingYour device may become warm during normal use.Faulty and damaged productsDo not attempt to disassemble the device or its accessories.Only qualified personnel must service or repair the device or its accessories.If your device or its accessories have been submerged in water punctured or subjected to a severe fall, do not use until they have been checked at an authorised service centre.InterferenceCare must be taken when using the device in close proximity to personal medical devices, such as pacemakers and hearing aids.PacemakersPacemaker manufacturers recommend that a minimum separation of 15cm be maintained between a device and a pacemaker to avoid potential interference with the pacemaker.