System Configuration 3-1Chapter 3System ConfigurationThis chapter describes how to use the Telnet-based management screens to access and configure advancedfeatures of your equipment. You can customize these features for your individual setup. These menus provide apowerful method for experienced users to set up their Router’s system configuration.System Configuration FeaturesThe Netopia Router’s default settings may be all you need to configure. Some users, however, require advancedsettings or prefer manual control over the default selections. For these users, Netopia Firmware Version 8.7provides many advanced system configuration options.This section covers the following topics:To access the system configuration screens, select System Configuration in the Main Menu and press Return.• “IP Setup” on page 3-2 • “Wireless configuration” on page 3-23• “Filter Sets” on page 3-2 • “Console Configuration” on page 3-35• “IP Address Serving” on page 3-2 • “SNMP (Simple Network Management Protocol)”on page 3-36• “Network Address Translation (NAT)” onpage 3-2• “Security” on page 3-36• “Stateful Inspection” on page 3-3 • “Upgrade Feature Set” on page 3-36• “Procedure for Default Installation for ICSAfirewall certification of Small/MediumBusiness Category Module (ADSL Routers)”on page 3-48• “Router/Bridge Set” on page 3-37• “VLAN Configuration” on page 3-11 • “IGMP (Internet Group Management Protocol)” onpage 3-39• “Date and time” on page 3-22 • “Logging” on page 3-42
