GEO M10 HARDWARE SETUP PROCEDURE Page 31/796.3.3 GEO M10 only on Touring Bumper with stacking extensionsRequired item- 1 x VNT-BUMPM10- 1 x VNT-GSTKM10S- 1 x VNT-GSTKM10LIMPORTANTGround stack assembly BUMPM10 + GSTKM10S + GSTKM10L is rated for a maximum of6 x GEO M10 in any inter cabinet angle configuration with +/-12° initial angle, providedthis device is assembled according to below rules:- BUMPM10 must be adjusted to be horizontal- Public is not allowed within a safety area which radius is equal or higher thanassembly height.- It is highly recommended to secure the system to a fix point located at the back of thestack.Procedure- Set the bumper on the ground so that front with front direction indicated by side arrows- Insert GSTKM10L and/or GSTKM10S guides into bumper front and rear center slotsIMPORTANTIf bottom GEO M10 angle is negative, GSTKM10L must be connected at the front andGSTKM10S at the backIf bottom GEO M10 angle is positive, GSTKM10S must be connected at the front andGSTKM10L at the back- Lock GSTKM10L and/or GSTKM10S into bumper with BUMPM10 quick release pin 1240.- Adjust feet height so that bumper is horizontal
