GEO M12 HARDWARE SETUP PROCEDURE Page 41/906.3.5 MSUB18 and GEO M12 on Touring Bumper with stacking extensionsRequired item- 2 x VNT-BUMPM12- 1 x VNT-GSTKM10M12S- 1 x VNT-GSTKM10M12LIMPORTANTGround stack assembly VNT-BUMPM12 + VNT-GSTKM10M12S + VNT-GSTKM10M12L israted for a maximum of 2 x MSUB18 + 6 x GEO M12 in any inter cabinet angleconfiguration with +/-12° initial angle, provided this device is assembled according tobelow rules:- VNT-BUMPM12 must be adjusted to be horizontal- Public is not allowed within a safety area which radius is equal or higher thanassembly height.- It is highly recommended to secure the system to a fix point located at the back of thestack.Procedure- Set the bumper on the ground so that front with front direction indicated by side arrows- Insert VNT-GSTKM10M12L and/or VNT-GSTKM10M12S guides into bumper front and rear centerslotsIMPORTANT- If bottom GEO M12 initial angle is negative, VNT-GSTKM10M12L must be connectedat the front and VNT-GSTKM10M12S at the back- If bottom GEO M12 initial angle is positive, VNT-GSTKM10M12S must be connectedat the front and VNT-GSTKM10M12L at the back
