Page 62/90 GEO M12 HARDWARE SETUP PROCEDURE- Once last GEO M12 has been removed, unlock and remove bottom bumper- Lower MSUB18s on the ground, unlock front and rear rigging points and lift cluster to remove bottomMSUB18.- Repeat until last MSUB18 is removed- Disassemble top bumper.6.5 Permanent Installation variantAll procedures described above apply to installation versions, with the exception of bumper and cabinetconnections, which are described below:Configuring VNI- BUMPM12 for GEO M12-I Left or Right- Adjust the front rigging point to required configuration and lock with provided screws (screws M8x45,washers M8, brake nuts M8).
