NXWIN4 SOFTWARE FOR NXAMP FIRMWARE UPGRADEAt the end of the download the NXAMP will start up normally, displaying the new firmwarerevision.Using the controller after a firmware updateChoosing a cabinet setupAfter the download of a new firmware, the NXAMP powered TDcontroller will be by defaultin FLAT mode, it means that the audio flows from the inputs to the outputs withouttreatment.To load the wanted setup (for example GeoD or PS15, …) you have to reset the unit byrepressing buttons A, B & “Select CH1” for 3 seconds at least.0. FLAT - NO PROTN.[4 ch amplifier] ~ ~(For 3 seconds)Selecting cabinet familySimultaneously repressing A & B buttons at power up or during device RESET accesses thesystem change menu. Keep the A & B Buttons held until the default display appears(approx. 3 seconds). This will allow the selection of any cabinet in any family. Using therotary encoder, scroll through the configurations and press “B” to load the requiredsettings.42. GeoD PA WBBack1-3 Front2-4 OK~ ~Select your cabinet set-upIn the ‘Options’ menu, choose “Systm Config”, and you will be able to choose among thedifferent set-ups within the same cabinet family, (i.e. you don't have to modify theamplifier to cabinet wiring) or eventually between all families (see above), or to build yourown custom setup.PAGE 124 OF 140
