QUICK STARTSelect your cabinet set-upIn the Options menu, choose Systm Config, and you will be able to choose among thedifferent set-ups within the same cabinet family. (i.e. you don't have to modify theamplifier to cabinet wiring). Press All button and all setups will be available for selection.Using the amplifier without the TDcontroller functionalityIf you want to use the amplifier without the TDcontroller, just choose the “FLAT mode”setup. In this mode, no EQ and no protection is applied to the cabinets. Please note thatthe amplifier will still have 0.5 ms analog input to analog output latency in that mode(warning, this latency is not the same than a NX242 TDcontroller in flat mode, seeintroduction for compensating values).In Flat mode, full amplifier digital protections are still available, and some functionality likevolume control, input patching, mute, delay, gain and ArrayEQ are working. Remotecontrol can be used as well.Back to defaultStartup the amplifier with the ‘Select CH1’ button down and you will have the possibilityto reset the settings to default (except if the local controls have been locked, see further).Auto saveThe current set-up is automatically saved three seconds after the last change of aparameter. At power up the last saved settings are restored.Enter the download modeKeep the ‘Mute 1’ button down during boot up will enter the download mode. See furtherfor connection to the computer and download software (Nxwin) description.PAGE 21 OF 140
