Nicol Scales & Measurement LoadRunner Series Installation & Service Manual
                               | |
Contents
| 
18 LoadRunnerâ„¢ Series Installation & Service Manual4.6 Configuration of ModesWith the inclinometer option turned on, the inclinometer screen is visible by switching display screens whenpressing the menu button.The display screen will toggle between the following when configured for:Gross Mode:Toggles between gross only weight display, inclinometer standard display and menu modeNet Mode:Toggles between net only weight display, inclinometer with net weight display and menu modeNet and Gross Mode (factory recommended setting):Toggles between net only weight display, gross only weight display, inclinometer with net weight display andmenu mode.To set mode:1. In MENU, select Options.2. Press (OK).3. In OPTIONS menu, select Modes.4. Press (OK).5. In MODES menu, press to toggle betweenNET & GROSSGROSSNET6. Press to confirm setting.4.7 CalibrationCalibration requires the use of a truck scale in order to calibrate the system. First determine the empty vehicleweight or tare weight of the truck. Once the tare and zero calibration are performed, load the vehicle as close to itslegal maximum limit as possible to determine the span or net weight value used for calibration.4.7.1 Calculating the SPAN (Net Weight)1. To determine actual TARE weight, drive the empty vehicle onto a truck scale and note the total weight.Truck ScaleFigure 4-4. Vehicle on Truck Scale2. Load the vehicle as close to its legal maximum as possible.3. Weigh the loaded vehicle, using the same truck scale, and record the GROSS vehicle weight.4. Calculate NET weight using: Gross - Tare = Net.Note Prior to calibration, with the display in the Inclinometer/Net Weight or Inclinometer mode raise the body clear ofthe chassis (the factory recommendation is three or four degrees). Record the bubble indication setting for useon span calibration and normal weighing. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine