Nidec Unidrive M400 series Quick Start Manual

Also see for Unidrive M400 series: Power Installation Guide Installation sheet User guide Step-by-step guide Step-by-step guide

Nidec Unidrive M400 series Quick Start Manual Manual pdf 65 page image

Unidrive M400 Quick Start Guide 65Issue Number: 89 NV Media Card OperationFigure 9-1 Installing the AI-Backup adaptor (SD Card)1. Identify the two plastic fingers on the underside of the AI-Backup adaptor (1) - then insert the twofingers into the corresponding slots in the spring-loaded sliding cover on the top of the drive.2. Hold the adaptor firmly and push the spring loaded protective cover towards the back of the drive toexpose the connector block (2) below.Press the adaptor downwards (3) until the adaptor connector locates into the drive connection below.Figure 9-2 Basic NV Media Card operationThe whole card may be protected from writing or erasing by setting the read-only flag, refer to the ControlUser Guide for further information. The card should not be removed during data transfer, as the drive willproduce a trip. If this occurs then either the transfer should be reattempted or in the case of a card to drivetransfer, default parameters should be loaded.The drive supports SD cards formatted with the FAT32 file system only.121113Pr = +00.030 ReadDrive reads allparameters fromthe NV Media CardPr = Prog +00.030 ramPrograms all driveparameters to theNV Media CardNOTEOverwrites anydata already indata block 1Pr = Auto +00.030Drive automaticallywrites to theMedia Cardwhen a parametersave is performedPr = oot +00.030 BDrive boots from theNV Media Card onpower up andautomatically writesto the Media Cardwhen a parametersave is performed121212NOTE