Nidec Unidrive M700 User Manual
Also see for Unidrive M600: Design guideInstallation sheetMounting Installation SheetInstallation sheet
                                                                                                                                                                                                                        | |
Contents
| 
SI-Ethernet User Guide 203Issue: 3Safetyinformation Introduction MechanicalinstallationElectricalinstallation Getting started Parameters Key featuresand ProtocolsPC ToolsApplications Security Diagnostics Glossary ofterms IndexTable 10-2 Drive trip indications10.3 Ethernet sub trip codesTable 10-3 below shows the possible Ethernet sub trip codes displayed in Pr 0.10.070 and theirrelevant text strings.Table 10-3 Ethernet error codesTrip DescriptionSlotX HF The drive has detected that an Ethernet interface is present but is unable tocommunicate with it due to a hardware fault.SlotX Error User trip generated by the Ethernet interfaceSlotX Not Fitted This trip will occur if a drive slot was previously configured with an optionmodule but on power up, no option module was detected.SlotX DifferentThis trip will occur if a drive slot was previously configured with an optionmodule but on power up, a different option module was detected. Replacingthe option module with another one of the same ID number will not initiatethis trip. The trip will also occur if an option module is installed to apreviously unused slot.ValuePr 0.10.070 Sub trip string Description100 Link Loss Network link has been lost101 E/IP Timeout An Ethernet/IP RPI timeout trip has occurred102 E/IP Read Param Invalid read consistency parameter, is parameter readonly?103 E/IP Write Param Invalid write consistency parameter, is parameter readonly?104 E/IP Fault An unexpected Ethernet/IP error has occurred105 Modbus Timeout The Modbus connection has timed out106 Cyclic Timeout Cyclic Rx link timeout107 Cyclic RX Late Cyclic Rx data was received late108 INIT Switch Ethernet switch initialization error109 INIT PTP IEEE1588 (Precision Time Protocol) initialization error110 INIT Cyclic Cyclic data initialization error111 INIT Modbus Modbus TCP initialization error112 INIT SMTP Email (SMTP) initialization error113 INIT Ethernet/IP Ethernet/IP initialization error114 INIT TCP/IP TCP/IP initialization error115 Ethernet Failure Ethernet controller initialization error116 E/IP PLC IDLE Ethernet/IP PLC Idle117 Sync Task ORun Synchronous task overrun |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine