User’s Manual10Chapter 3: DVR/Camera installation3.1 Connecting the DVR to a TV or MonitorUsing the supplied BNC to RCA connector1. Connect the BNC to RCA connector to the back of the DVR labeled Video Output (refer toChapter 2.2, Rear Panel Picture)2. Connect the other end of the cable to an open RCA VIDEO input on your TV or Monitor3. Select the appropriate video input on your TV or Monitor to view the DVRNOTE: Your DVR must be powered on so you can view on your TV or Monitor.3.2 Connecting the Power Supply1. Plug the provided power supply into the back of the DVR labeled “DC12V”2. Plug the other end of the power Adapter into any 110V outlet within your home or business.NOTE: Connecting your DVR and Cameras power source into a UPS or battery backup system willprovide you recorded coverage after power failures. Time depends on type of UPS used.NOTE: Ensure the cable is pushed all the way into the power supply. Otherwise the DVR will notpower on!!3.3 Connecting the CamerasNOTE: Prior to mounting the cameras to their desired destination, please ensure all cameras areworking. Perform these steps near the DVR. Once all cameras are up and running, then you can laythe cables and mount the cameras to their desired location.1. Each NightOwl camera comes with 60ft. of cable per camera. Using one cable per camera,plug each BNC connector of the camera into the 60ft cable.2. Plug the other end of the cables into the back of the DVR labeled “CH1 thru CH16”3. Connect the provided 4-way power splitters to the DC jacks of the cameras, and plug thepower splitter to one of the camera adapters.4. Plug the camera adapters into any 110V outlet or UPS.