NightStick XPP-5418GX Instruction Manual

Also see for XPP-5418GX: Instruction manual Instruction manual Instruction manual

NightStick XPP-5418GX Instruction Manual Manual pdf 1 page image

Instruction ManualXPP-5418GX/RXPlease read these instructions before using your Nightstick XPP-5418 IntrinsicallySafe Flashlight. They include important safety information and operating instructions.THE XPP-5418GX/RX IS APPROVED FOR USECLASS I DIV 1 GRPS A-D T3CLASS II & III DIV 1 GRPS E-G T135ºCCLASS I ZONE 0 AEx ia IIC T3 GaEx ia IIC T3 GaEx ia op is IIC T3 GaIntertek ITS 13 ATEX27837XIECEx ITS 16.0067X-20ºC ≤ Tamb ≤ +40ºC1.5V/Cell with three in seriesEnergizer E91 or EN912575E 467756INTRINSICALLY SAFESECURITE INTRINSEQUEII 1 G Ex ia op is IIC T3 GaBayco Products, Inc. XPP-5418GX/RXWARNINGS:Replace batteries in a non-hazardous location.Use only Energizer AA Model E91 or EN91 batteries.AVERTISSEMENT:Remplacer les piles dans une zone non dangereuse.Utiliser uniquement les piles Energizer AA - modèle E91 ou EN91.Ex ia FLASHLIGHT FOR USE IN HAZARDOUS LOCATIONS640 S. Sanden Blvd., Wylie, TX 75098INMETROSegurançaNCCEx ia op is IIC T3 Ga(-20ºC ≤ Tamb ≤ +40ºC)15.0286 XWARNINGS - INTRINSICALLY SAFEy Warning: Use only the approved non-rechargeable batteries listed below.y Warning: Do NOT attempt to use rechargeable AA batteries with this light.y Warning: To prevent ignition of a hazardous atmosphere, do not open the lens bezelin the hazardous environment. This task must ONLY be performed in an area knownto be non-hazardous.y Warning: When exchanging batteries, use only Energizer EN91 or Energizer E91batteries.y Warning: To prevent ignition of a hazardous atmosphere, the AA batteries must onlybe exchanged in an area known to be non-hazardous.y Warning: To reduce the risk of explosion, do not mix new batteries with usedbatteries, or mix batteries from different manufacturers.y Warning: Substitution of components may impair intrinsic safety.SPECIAL INSTRUCTIONS FOR INTRINSIC SAFETYy For personal safety, always confirm the rating of any known hazardous or potentiallyhazardous location where the light is to be used.BATTERY INSTALLATIONWARNING: In order to maintain the XPP-5418’s Intrinsically Safe rating, the onlyAA batteries certified for use with this light are the Energizer EN91 or EnergizerE91 batteries.y Do not attempt to use any other brand or model of AA batteries.y Do not attempt to use any type of rechargeable AA batteries.Warning: To prevent ignition of a hazardous atmosphere, do not remove the lensbezel or the reflector / battery carrier in the hazardous environment. This taskmust ONLY be done in an area known to be non-hazardous.y Loosen the locking screw located on the side of the lens cap. NOTE: Do NOTattempt to completely remove the locking screw. Doing so is not necessary and maydamage the threads. The screw simply needs to be loosened enough to allow the lensbezel to unscrew.y Unscrew the lens bezel from the housing in a counter-clockwise direction.y Turn the light upside down and carefully shake the light in order to remove thebatteries. Allow the batteries to slide into your hand.y Using 3 – AA Energizer EN91 or Energizer E91 batteries (make sure thatall 3 batteries are of the same model), install the batteries in the carrier payingclose attention to the markings inside the housing for proper battery terminalpolarity alignment.y Replace the lens bezel by screwing it onto the housing in a clockwise direction.y Tighten locking screw. CAUTION: Do NOT over-tighten. Doing so may damage thethreads and impact the light’s Intrinsic Safety.OPERATIONTHE XPP-5418 HAS TWO SEPARATE LIGHTING MODES:MOMENTARY FLASHLIGHT MODELightly press the body switch for momentary operation. Release the switch to turnthe light off.CONSTANT-ON FLASHLIGHT MODEPress the body switch until it clicks and then release for constant-on mode. Pressand release the body switch again to turn the light off.

/ 2

Related manuals for NightStick XPP-5418GX