NightStick XPP-5422GMX Instruction Manual

Also see for XPP-5422GMX: Instruction manual

NightStick XPP-5422GMX Instruction Manual Manual pdf 1 page image

Bayco Products, Inc. • 640 South Sanden Blvd. • Wylie, TX 75098 • 1-800-233-2155 • 1-469-326-9400 • www.nightstick.comINS-XPP-5422GMX-20 02-20-2020Instruction ManualXPP-5422GMXPlease read these instructions before using your Nightstick XPP-5422GMXIntrinsically Safe Permissible Dual-Light Flashlight. They include important safetyinformation and operating instructions.THE XPP-5422GMX IS APPROVED FOR USECLASS I DIV 1 GRPS A-D T3CLASS II & III DIV 1 GRPS E-G T135CCLASS I ZONE 0 AEx ia IIC T3 GaCLASS I ZONE 0 Ex ia IIC T3 GaEx ia op is I MaEx ia op is IIC T3 GaIntertek ITS 13 ATEX27837XIECEx ITS 16.0067X-20ºC ≤ Tamb ≤ +40ºC1.5V/Cell AA Alkaline2575ID 4003544INTRINSICALLY SAFESECURITE INTRINSEQUEI M 1 Ex ia op is I MaII 1 G Ex ia op is IIC T3 GaConforms to:ANSI/UL STD 913, ANSI/UL60079-0, ANSI/UL 60079-11ANSI/ISA 60079-26Certified to:CAN/CSA STD C22.2 No 157CAN/CSA STD C22.2 No 60079-0CAN/CSA STD C22.2 No 60079-11CSA STD C22.2 No 25Bayco Products, Inc. XPP-5422GMXWylie, TX 75098640 S. Sanden Blvd.INMETROSegurançaNCCEx ia op is I MaEx ia op is IIC T3 Ga(-20ºC ≤ Tamb ≤ +40ºC)15.0286 XCAPACITANCE LIMITATION - INTRINSICALLY SAFEThe capacitance measured on the two magnets and the side clip exceeds 3pFfor Group IIC. The user shall determine the suitability of the equipment in the endapplication.WARNINGS - INTRINSICALLY SAFEy Warning: Use only the approved non-rechargeable batteries listed below.y Warning: Do NOT attempt to use rechargeable AA batteries with this light.y Warning: To prevent ignition of a hazardous atmosphere, do not open the lensbezel in the hazardous environment. This task must ONLY be performed in anarea known to be non-hazardous.y Warning: When exchanging batteries, use only Duracell PC1500, EnergizerEN91 or Energizer L91 batteries.y Warning: To prevent ignition of a hazardous atmosphere, the AA batteries mustonly be exchanged in an area known to be non-hazardous.y Warning: To reduce the risk of explosion, do not mix new non-rechargeablebatteries with used non-rechargeable batteries, or mix non-rechargeablebatteries from different manufacturers.y Warning: Substitution of components may impair intrinsic safety.SPECIAL INSTRUCTIONS FOR INTRINSIC SAFETYy For personal safety, always confirm the rating of any known hazardous orpotentially hazardous location where the light is to be used.BATTERY INSTALLATIONWARNING: In order to maintain the XPP-5422GMX’s Intrinsically SafePermissible rating, the only AA batteries certified for use with this light are theDuracell PC1500, Energizer EN91 or Energizer L91 batteries.y Do not attempt to use any other brand or model of AA batteries with this light.y Do not attempt to use any type of rechargeable AA batteries with this light.Warning: To prevent ignition of a hazardous atmosphere, do not remove thelens bezel or the reflector / battery carrier in the hazardous environment. Thistask must ONLY be done in an area known to be non-hazardous.y Loosen the locking screw located on the side of the lens cap. NOTE: Do NOTattempt to completely remove the locking screw. Doing so is not necessary andmay damage the threads. The screw simply needs to be loosened enough toallow the lens bezel to unscrew.y Unscrew the lens bezel from the housing in a counter-clockwise direction.y Turn the light upside down and carefully shake the light in order to remove thereflector / battery carrier. Allow the reflector / battery carrier to slide into yourhand. WARNING: Do NOT touch the reflector surface with your finger. Doingso may damage the reflector surface.y Using 3 – AA Duracell PC1500, Energizer EN91 or Energizer L91 batteries(make sure that all 3 batteries are of the same model), install the batteries in thecarrier paying close attention to the markings on the battery carrier for properbattery terminal polarity alignment.y Align the reflector / battery carrier so that the switches on the carrier are alignedwith the switches on the housing. Carefully insert the reflector / battery carrierback into the flashlight housing until it is fully seated in the housing. WARNING:Be careful to not touch the reflector surface with your finger. Doing so maydamage the reflector surface.y Replace the lens bezel by screwing it onto the housing in a clockwise direction.y Tighten locking screw. CAUTION: Do NOT over-tighten. Doing so maydamage the threads and impact the light’s Intrinsic Safety.OPERATIONTHE XPP-5422GMX HAS FOUR SEPARATE LIGHTING MODES:Momentary Flashlight ModeLightly press the top body switch for momentary operation. Release the switchto turn the light off.Constant-on Flashlight ModePress the top body switch until it clicks and then release for constant-on mode.Press and release the top body switch again to turn the light off.Floodlight ModePress the bottom body switch until it clicks and then release for floodlightmode. Press and release the bottom body switch again to turn the light off.Dual-Light ModeDual-Light allows the user to turn on both the Flashlight and the Floodlight, at thesame time. Press the top body switch until it clicks and then release for constant-on mode Flashlight Mode. Next press and release the bottom switch to activatethe Floodlight. Both the Flashlight and the Floodlight are now running. Press andrelease both the top and bottom body switches to turn the lights off.WARRANTYLIMITED LIFETIME WARRANTYBayco Products, Inc. warrants this product to be free from defects inworkmanship and materials for the original purchaser’s lifetime. The LimitedLifetime Warranty includes the LEDs, housing and lenses. Rechargeable batteries,chargers, switches, electronics and included accessories are warranted for aperiod of two years with proof of purchase. Normal wear and failures which arecaused by accidents, misuse, abuse, faulty installation and lightning damage areexcluded.We will repair or replace this product should we determine it to be defective.This is the only warranty, expressed or implied, including any warranty ofmerchantability or fitness for a particular purpose.For a complete copy of the warranty, go to www.baycoproducts.com/bayco-product-support/warranties. Retain your receipt for proof of purchase.