Nikken Pimag Aqua Pour Operating Manual
                    | |
Contents | 
-6-Optional ceramic filterYou may use the ceramic filter (P) in place of the microsponge. This component isdesigned for intensive filtration, which removes a greater amount of material sedimentsand requires a longer time to operate.Rinse the ceramic filter in cold water for 1-2 minutes before use, or soak the filter in coldwater for approximately 10 minutes before installing it.• To use the ceramic filter, remove the microsponge filter from the opening in the plate.IMPORTANT: You cannot use both prefilters at the same time.• Attach the washer and the filter adapter to the ceramic filter.• Place the ceramic filter ring seal in the opening in the plate.• Place the ceramic filter upright (with the dome upward) on top of the plate, and fromunderneath the plate tighten the nut.• Replace plate on top of water tank cover.The ceramic filter may require up to five hours to complete the filtration of an entire tankof water.REFILLING THE TANKDo not overfill the unit. If the lower (supply) tank is 2/3 full, do not fill the upper (fill) watertank more than halfway. Overfilling the tank may cause the unit to overflow.MAINTENANCEKeep the PiMag™ Aqua Pour™ Gravity Water System away from direct sunlight.Hand wash the water tanks periodically (approximately once a month) to keep them cleanand free of deposits. You may use a mild detergent or soap. When cleaning the unit, donot use a scrubber or paper towels, which may result in scratches on the surface. Use asoft cloth to dry.The microsponge filter and ceramic filter may be washed if they become discolored orwater flow is reduced. Wash in cold water only.Do not boil the filter cartridge. Clean only by rinsing in cold water.FILTER REPLACEMENTThe microsponge filter must be replaced if its surface becomes permanently discolored orhardened.The filter cartridge should be replaced after six months of normal use, or after 2,000 litershave been filtered, whichever comes first. Cartridge life will vary, depending on amount ofuse and water quality. See the recommended replacement intervals in the Specificationssection.REPLACEMENT PARTSThe following replacement parts may be ordered from Nikken Inc.Filter Cartridge #1361Microsponge Filter #1362Ceramic Filter #1364Mineral Stones #1386 |
Related manuals for Nikken Pimag Aqua Pour
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine